Table of Contents
Advertisement
4.13 Display Mask
Removing the Display Mask
To remove the display mask, follow the steps below and refer to figure 4-26.
1.
Turn the computer off. Disconnect the AC power cord and all external cables
connected to the computer.
2.
Remove the battery pack, optional PC card, and optional memory module as
described in sections 4.2, 4.3, and 4.4.
NOTE: It is not necessary to remove the display assembly.
Remove two rubber seals from the display hinges to expose two screws securing
3.
the display mask .
Remove two M2.5x6 screws that were covered by the rubber seals.
4.
5.
Carefully insert your fingers between the mask and the LCD panel and pry open
the latches. Start with the six latches across the top of the display mask.
Continue releasing the mask along the sides (four latches on each side), at the
6.
bottom (three latches), and display supports ( one latch at the small display
support and three latches at the larger display support are not indicated in figure
4-26).
100CS
Figure 4-26 Removing the display mask
4-29
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
