Table of Contents
Advertisement
3.1
The Diagnostic Test
This chapter explains how to use the Diagnostic Test program to test the functions of the
computer's hardware modules. The Diagnostics Program is stored on the Diagnostic Disk.
The Diagnostic Test consists of 11 programs that are grouped into the Service Program
Module (DIAGNOSTIC TEST MENU) of the Test Program Module (DIAGNOSTIC
TEST).
NOTES: To start the diagnostics, follow these steps:
1. Check all cables for loose connections.
2. Exit any application you may be using and close Windows.
3. Be sure the computer is not in virtual 86 mode The test will not run in that mode.
If you try to run the test in virtual 86 mode, the following message will be displayed:
Cannot execute in a virtual 8086 mode.
If the preceding message is displayed, remove memory managers from your
config.sys file. See your MS-DOS documentation for information on the config.sys
file.
The DIAGNOSTICS MENU consists of the following functions.
K DIAGNOSTIC TEST
K HARD DISK FORMAT
K HEAD CLEANING
K LOG UTILITIES
K RUNNING TEST
K FDD UTILITIES
K SYSTEM CONFIGURATION
K EXIT TO MS-DOS
K SETUP
100CS
3-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
