Table of Contents
Advertisement
Remove five M2.5x6 screws securing the metal cover and lift out the cover. Note
5.
that one screw secures the ground cable.
Figure 4-12 Removing the metal cover and disconnecting the keyboard cable
Disconnect the keyboard cable from PJ13 on the system board.
6.
Installing the Keyboard
To install the keyboard, follow the steps below and refer to figures 4-11 and 4-12.
Connect the keyboard cable to PJ13 on the system board.
1.
Seat the metal cover (note the end that goes under) and secure it with five
2.
M2.5x6 screws . Be sure to replace the ground cable.
Seat the keyboard .
3.
Seat the keyboard base and secure the 14 latches .
4.
5.
Install the HDD, optional memory module, optional PC card, and battery pack as
described in sections 4.5, 4.4, 4.3, and 4.2.
100CS
4-15
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
