Table of Contents
Advertisement
Remove one M2.5x6 screw securing the holder assembly (underneath the AC PS
9.
unit) and lift out the assembly.
Lift the power cord socket straight up until it clears its slots and remove the AC
10.
PS unit.
Installing the AC PS unit
To install the AC PS unit, follow the steps below and refer to figures 4-23 and 4-24.
Seat the power cord socket in its slots.
1.
Seat the holder assembly , secure it with two M2.5x6 screws , and replace the
2.
tape.
Seat the AC PS unit.
3.
Secure the AC PS unit with one M2.5x10 silver screw .
4.
Connect the AC power cable to PJ502 and secure the cable with tape.
5.
Seat the VGA cable guard and secure it with one M2.5x6 screw .
6.
7.
Install the FDD, top cover and display assembly, membrane switch, sub-battery
and VGA assembly, keyboard, HDD, optional memory module, optional PC card,
and battery pack as described in sections 4.10 back through 4.2.
100CS
Figure 4-24 Removing the holder assembly
4-27
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
