Table of Contents
Advertisement
Installing the DSTN FL Inverter Board
To install the FL inverter board, follow the steps below and refer to figure 4-27.
Seat the FL inverter board .
1.
Connect the FL inverter cable to CN1 and the FL cable to CN2 on the FL
2.
inverter board and seat the board.
Connect the contrast control board cable and seat the board.
3.
Secure the contrast control board with one M2.5x6 screw .
4.
Secure the FL inverter board with two M2.5x6 screws .
5.
Replace the tape over the FL inverter board cables.
6.
7.
Install the display mask, optional memory card, optional PC card, and battery pack
as described in 4.13, 4.4, 4.3, and 4.2.
4-32
100CS
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
