Table of Contents
Advertisement
(a)
Serial Port
This option allows you to set the COM level, COM1 or COM2, for the
serial port and PC card slot. The serial port interrupt request level (IRQ) and
I/O port base address for each COM level is shown below:
NOTE: Do not assign the same interrupt request level and I/O address
to serial port and PC card.
(b)
Parallel Port
This option sets the address for the parallel port. The options are:
LPT3 (3BCH) :
When you select one of the above options, except for Not used, a sub-
window similar to the one below appears to let you set the parallel port
mode. Options for this setting are ECP (default) and Std. Bi-Directional .
For most printers, the port should be set to ECP. With some other parallel
devices, the setting should be Std. Bi-Directional .
6.
Others
Whether or not you need to configure the computer with these options depends
primarily on the kind of software or peripherals you use.
(a)
Power-up Modes
This option lets you choose between AutoResume and boot mode. You can
also set this option using hotkeys. AutoResume is effective with either the
internal LCD or with an external monitor.
3-54
COM level
Interrupt level I/O address
COM1
4
COM2
3
COM3
4
COM4
3
Not used
LPT1 (378H) :
Sets the address to 378H. (Default)
LPT2 (278H) :
Sets the address to 278H.
Sets the address to 3BCH.
Not used:
Disables the port.
Option
Mode
=
Boot
Turns on boot mode. (Default)
Resume
Turns on the AutoResume feature.
3F8h
(Serial port default)
2F8h
3E8h
2E8h
(Disables port)
ECP
100CS
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
