Table of Contents
Advertisement
2nd
3rd
DisplayPort Ver.
Input Port Ver.
Auto Source Switch+
Key Repeat Time
Power LED On
Setup Custom Key
VRR Control
Description
Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the product (in
DisplayPort
mode) is displaying the message
button to display the Function Key Guide screen and then select
― If setting the
DisplayPort Ver.
to 1.1, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual maximum output refreshing rate of the graphics
cards cannot achieve the level of 120Hz / 144Hz / 165Hz (S27CG55*/S32CG55*), 120Hz / 144Hz / 180Hz (S27DG50*/S32DG50*).
― If the PC has entered BIOS mode and the BIOS screen does not appear, go to the following path and then select the mode.
Select an HDMI version.
(1.4
/ 2.0↑)
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the HDMI mode to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
― Set HDMI mode to
1.4
if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays a blank screen, or does
not play sound at all.
By activating, a new connected source is displayed automatically.
― This function may not be supported depending on the model or geographical area.
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
2 sec
can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
•
Working: The power LED is on when the product is turned on.
•
Stand-by: The power LED is on when the product is turned off.
Set the custom key so that your chosen function can be set up directly.
•
Eye Saver Mode
/
Refresh Rate
/
Low Input Lag
By optimising the video signal processing, this additional function mitigates screen flicker.
While playing any game or content that causes screen flicker, use the
― S27CG55* / S32CG55* models only.
Check the cable connection and the settings of the source device.
→
System
→
DisplayPort
Ver..
No Repeat
is selected, a command responds only once when a button is pressed.
/
Black Equalizer
/
Virtual Aim Point
/
Auto Source Switch+
VRR Control
function with setting it to On.
press the 5-Way / JOG
→
System
→
DisplayPort
Ver..
/
Picture Mode
/
Response Time
34
Advertisement
Table of Contents
