Table of Contents
Advertisement
S27DG50* / S32DG50*
― Disassembly is the reverse order of assembly.
2
Push the assembled stand into the main body in the direction of the
arrow as shown in the figure.
Confirm that the stand is tightly fastened. If
lowered, lower it while holding it with your hand.
5
Stand assembly is complete.
1
Check the direction of the arrow on the stand base. Align the direction of the arrow on the stand base with the front direction of the stand
neck, and then insert the stand neck from top to bottom.
Turn the stand neck clockwise to fasten it to the base. Lift the stand slightly and check that the PUSH button on the bottom of the base
protrudes.
3
Attach the COVER-REAR TOP to the rear of the monitor, as shown in the figure.
has not been fully
Caution
Do not arbitrarily remove the panel
film. If not observed, the warranty
service may be restricted.
Separating the stand neck from the stand base
Lift the assembled stand slightly and press the PUSH button on the bottom of the base.
While holding down the PUSH button, turn the stand neck anticlockwise to remove it.
4
Stand up the monitor as shown in the figure.
10
Advertisement
Table of Contents
