Advertisement
Quick Links
Filter Relocation Kit
Greensmaster
Model No. 120-3171
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Fuel hose
Small plastic cable tie
Large plastic cable tie
800 cc carbon canister
Inline vent filter
Hose clamp
Bracket
Clamp
Hex head bolt (1/4 x 5/8 inch)
Hex flange nut
1. Remove the fasteners that hold the right-hand
console in place, and remove the console (Figure 1).
Figure 1
1. Fasteners
2. Remove and discard the carbon canister with the
in-line vent filter and the short connecting hose.
3. Install a new carbon canister from loose parts.
4. Connect the hoses to the fittings on top of the
canister, and secure them using the existing hose
clamps.
5. Secure one end of the new fuel hose (from the loose
parts bag) to the bottom of the carbon canister with
a new hose clamp (Figure 2).
© 2010—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3150
Qty.
1
3
1
1
1
Install the kit.
2
1
1
1
1
1. Carbon canister
2. Hose clamp
6. Secure the fuel hose to the canister with the large
plastic tie as shown in Figure 2.
Note: Ensure that the hose does not kink or
collapse when you install the large plastic tie.
7. Route the fuel hose by following the wire harness,
and secure the hose to the wire harness with small
cable ties (Figure 3).
Register at www.Toro.com.
Form No. 3367-208 Rev A
Installation Instructions
Use
Figure 2
3. Fuel hose
4. Large plastic tie
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Advertisement
Related Manuals for Toro 120-3171
Summary of Contents for Toro 120-3171
- Page 1 Form No. 3367-208 Rev A Filter Relocation Kit Greensmaster ® 3150 Model No. 120-3171 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Fuel hose Small plastic cable tie Large plastic cable tie...
- Page 2 12. Slip on a hose clamp on the open end of the fuel hose and insert the new inline vent filter. 13. Secure the vent filter to the hose with a hose clamp (Figure 5). Note: Ensure that the open end of the vent filter is horizontal or lower.