Advertisement
Quick Links
Rear Roller Extension Kit
Greensmaster
Model No. 125-5180
Installation
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
1. Raise the rear of the cutting unit and place a block
under the bedknife.
2. Remove and discard the 2 nuts securing each roller.
Retain the shim, but discard the bolts, roller spacer, and
roller retainer (Figure 1).
1. Mounting nuts
2. Side plate mounting flange 5. Roller retainer
3. Shim
3. Install the loose parts and previously removed shim
as shown in Figure 2 or Figure 3, depending on the
desired height-of-cut.
4. Adjust to the desired height-of-cut, and tighten the
height of cut arm mounting fasteners.
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
DPA Reel Mowers
Figure 1
4. Roller spacer
Register at www.Toro.com.
Figure 2
Height-of-cut between 3–25 mm (1/8–1 inch)
1. Flange-head nut
2. Shim
3. Set screw
4. Roller spacer
Original Instructions (EN)
All Rights Reserved *3376-266* A
Printed in the USA
Form No. 3376-266 Rev A
Installation Instructions
5. Roller retainer
6. Long bolt
7. Short bolt
Advertisement
Related Manuals for Toro 125-5180
Summary of Contents for Toro 125-5180
- Page 1 Form No. 3376-266 Rev A Rear Roller Extension Kit Greensmaster ® DPA Reel Mowers Model No. 125-5180 Installation Instructions Installation WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Figure 3 Height-of-cut between 1.5–6 mm (1/16–1/4 inch) 1. Flange-head nut 5. Roller retainer 2. Shim 6. Long bolt 3. Set screw 7. Short bolt 4. Roller spacer...