Table of Contents
Advertisement
Quick Links
Trimmer Rack
GrandStand
Model No. 145-3530
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
1
2
3
4
© 2023-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Revolution
Description
Hex-head flange screw (1/4 x 1-1/2
Hex-head flange screw (1/4 x 1-1/2
Register at www.Toro.com.
®
Mower
Qty.
-
Prepare the machine for installation.
1
3
1
2
Install the upper bracket assembly.
4
1
1
2
1
2
1
2
Install the lower mount bracket.
4
1
1
2
-
Complete the installation.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3463-130 Rev A
Installation Instructions
Use
*3463-130*
Advertisement
Table of Contents
Related Manuals for Toro 145-3530
Summary of Contents for Toro 145-3530
-
Page 1: Table Of Contents
Form No. 3463-130 Rev A Trimmer Rack GrandStand ® Revolution ® Mower Model No. 145-3530 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine for installation. -
Page 2: Procedure
Preparing the Machine No Parts Required Procedure Park the machine on a level surface. Disengage the drives and the power take-off. Shut off the machine and remove the key. Wait for all moving parts to stop. g377627 Turn the battery-disconnect switch to the O Figure 2 position. -
Page 3: Upper Mount Bracket
WARNING Using a drill without proper eye protection may allow debris to enter the eye, causing injury. Installing the Upper Bracket When drilling, always wear eye Assembly protection. Use a drill bit (9/32 inch) to drill through the 3 Parts needed for this procedure: marked hole locations. -
Page 4: Hex-Head Flange Screw
Installing the Lower Mount Bracket Parts needed for this procedure: Lower mount bracket Screw (5/16 inch) Adjustment plate Carriage bolt (1/4 x 3/4 inch) Nut (1/4 inch) g441543 Small fist clamp Figure 5 Small backer plate 1. Slot bracket 3. Nut (1/4 inch) Hex-head flange screw (1/4 x 1-1/2 inches) 2. -
Page 5: Lower Mount Bracket
Use 2 hex-head flange screws (1/4 x 1-1/2 WARNING inches) and 2 nuts (1/4 inch) to secure the Using a drill without proper eye small backer plate and small fist clamp to the protection may allow debris to enter the adjustment plate. -
Page 6: No Parts Required
Note: Position the upper trimmer handle so that is held in place by the upper clamp. Completing the Installation No Parts Required Procedure Install the rear access cover. g442743 Figure 13 g377627 Figure 11 Raise the cushion to the platform. Tighten the twist knobs on each side of the machine. - Page 7 Notes:...