ROOM AIR CONDITIONER INDOOR UNIT OUTDOOR UNIT MC18AC2X MC18AC2-09 MC19AC2-07 MC19AC2X MC19AC2-12 MC24AC2-12 MC24AC2X Manual SERVICE AIR CONDITIONER CONTENTS 1. Precautions 2. Product Specifications 3. Operating Instructions and Installation 4. Disassembly and Reassembly 5. Troubleshooting 6. Exploded Views and Parts List 7.
Relocate the unit if necessary. 9. Keep children away from the unit while it is being repaired. 10. Be sure to clean the unit and its surrounding area. Fig. 1-3 No Kids Nearby! Fig. 1-4 Clean the Unit Samsung Electronics...
2-1 Table MC18AC2 MC19AC2 MC24AC2 Model INDOOR UNIT OUTDOOR UNT INDOOR UNIT INDOOR UNIT OUTDOOR UNIT INDOOR UNIT OUTDOOR UNIT Item MC18AC2-09 MC18AC2X MC19AC2-07 MC19AC2-12 MC19AC2X MC24AC2-12 MC24AC2X Type Wall-Mounting Multi Split Wall-Mounting Multi Split Wall-Mounting Multi Split 2.65 2.05 5.55...
Page 5
2-2 Dimensions 2-2-1 Indoor Unit (Unit : mm) (Front view) Air out (Remote control) Installation plate Samsung Electronics...
To select the 5 way function with the remote control, press the 5 way button one or more times until the desired mode is selected. Each time you press the 5 way button. Each 5 way indicator on the indoor unit comes on in order. Samsung Electronics...
Page 9
30 minutes, turbo operation mode is canceled and returned to the previous mode. *But, if you pressed the TURBO button in DRY or FAN mode that is changed with AUTO mode automatically. Samsung Electronics...
Page 10
*OFF TIMER : Both timer and operation LED lights on. 11. BUZZER SOUND : Whenever the ON/OFF button is pressed or whenever change occurs to the condition which is set up or select, the compulsory operation mode, buzzer is sounded "beep". Samsung Electronics...
Page 11
It is harmful to the air conditioner if it is used in the following environments: greasy areas (including areas near machines), salty areas such as coast areas, areas where sulfuric gas is present such as hot spring areas. Contact your dealer for advice. Samsung Electronics...
125mm or more 125mm or more Cut the piping hole sloped slightly Remote control Outdoor unit check point A-UNIT B-UNIT Piping (Liquid) 1/4" Clamper tube Piping (Gas) 3/8" Installation plate Installation tube Pipe-connection Vinyl tape Screw Putty Drain hose Samsung Electronics...
Page 13
Result : All inert gas escapes from the indoor unit. • To prevent dirt or foreign objects from getting into the pipes during installation, do NOT remove the caps completely until you are ready to connect the piping. Samsung Electronics...
Page 14
4. Pass the drain hose through the hole in the wall, making sure that it is sloping downwards, as shown in the illustrations above. The hose will be fixed permanently into position once Shield the whole installation has been tested for gas leaks; Drain hose Extension drain hose Samsung Electronics...
Page 15
5 Connect the power cable to the auxiliary circuit breaker. Outdoor unit erminal block (N ) Earth terminal Circuit Breaker (Main Power supply cable) Earth Earth terminal terminal Assembly cable Earth Earth terminal terminal Indoor unit B-unit A-unit Samsung Electronics...
Page 16
Terminal used exclusively for grounding Grounding resistance: less than 100 ohms (existing grounding electrode) Grounding screw hole 2. Use of a grounding electrode. • Specifications of grounding electrode. Carbon plastic Steel core PVC-insulated wire(2mm x3.5m), green Terminal, M4 Samsung Electronics...
Page 17
And mount the service port cap to 3-way valve. (gas) Stem cap 7. Check for gas leakage. - At this time, especially check for gas leakage from the 3-way valve’s stem nuts, and from the service port cap. 3-10 Samsung Electronics...
Page 18
R410A operating a pressure valve. 7. Stop operation of the air conditioner. 8. Close the 3-way valve, disconnect the pressure gauge, and open the 3-way valve again. 9. Close the cap of each valve. Samsung Electronics 3-11...
Page 19
5~10m R410A(Add as liquid state) for every 1m. state) for every 1m 3-2-2(i) Flare nut fixing torque Torque (kg-cm) Outer diameter Fixing Torque Final Torque ø 6.35 (Liquid Side) ø 9.52 (Gas Side) ø 12.7 (Gas Side) 3-12 Samsung Electronics...
Page 20
At this time, cover the pipe of the indoor 8. Remove the mounting plate for the indoor unit and the other pipe using a cap or vinyl unit and move it to a new location. plug to avoid foreign material entering. Samsung Electronics 3-13...
7) Pull the upper left and right of discharge softly for the outside cover to be pulled out. 8) Pull softly the lower part of discharge and push it up. Caution; Assemble the front panel and fix the hooks of left and right. Samsung Electronics...
Page 23
2) Loosen the fixing two screws and separate the motor holder. 3) Loosen the fixing screw of fan motor. (By use of M3 wrench) 4) Separate the fan motor from the fan. 5) Separate the fan from the left holder bearing. Samsung Electronics...
Page 24
Fan Motor 1) Do Procedure “1” above. <MC18AC2X, MC19AC2X> & Propeller Fan 2) Remove the nut flange. (Turn to the right to remove as it is a left turned screw) 3) Disassemble the propeller fan. <MC24AC2X> Samsung Electronics...
Indoor unit heat exchanger temperature sensor Error (open or short) BIO LED blinking (1Hz) Indoor fan malfunctioning (for speed is Below 450rpm) STD, BIO and TIMER LED blinking(1HZ) EEPROM Error All LED blinking(1HZ) Option Error (option wasn’t setup or option data error) Samsung Electronics...
Check PCB pattern. Replace ICO2 Replace main PCB. 10ms Is voltage output terminal of PC814(PC02) normal? Are voltage at #11 and #12 of the micom normal? Replace resonator (X301) 250ns Replace PC814(pc02) Is operation normal? Replace micom Samsung Electronics...
Page 28
Test rod location Normal voltage PCB CN72 Condition Fan operate about AC 180V pin #3 and #5 MF-C is out of order Replace MFC Fan motor Fan motor is out of order. should be replaced. Samsung Electronics...
Power relay should be Is rating voltage ±10% range applied relay between Terminal block out of order replaced. NO(N1) and No. 1 Outdoor unit is out of order. Is the room sensor normal register? 10°C 20°C 30°C 17.96kΩ 12.09kΩ 8.3kΩ Samsung Electronics...
Page 30
After training on, the Cooling operation should Normal start in five minutes. Is the number #33 of Micom (IC04) DC 5.0 V? Abnormal Micom Abnormal IC06 Is the number checking #10 of IC06 (ULN2003AFW) LOW? RY01 or Cable Check. PCB should be replaced. Samsung Electronics...
Voltage at PIN #30 of Remocon Micom change? Voltage at collector of Q601 or Q602 change? Q601(C4375Y) or Q602(C1623Y) is faulty. IR LED(CL-1L5EU) is faulty. Voltage at pin #26 of micom (IC04) change (INDOOR UNIT)? Receiver module is faulty. Micom (IC04) is faulty. Samsung Electronics...
Page 32
5-3-2 Procedure The parts should be replaced in the following procedure. Check for any faulty part. Detach the faulty part. Replace it with a new part. Check the operation of the new part. The repair is completed. Samsung Electronics...
Page 33
Voltage check SMPS circuit is faulty 1. check voltage of IC06 IC06 is faulty (pin#10,pin#8) Set the TURBO mode : relay on 0.7[v] : relay off 12[v] 2. Voltage at terminal block RY71 is faulty ((N1) -1) rating voltage Samsung Electronics...
350Ω ±10% 340Ω ±10% 340Ω ±10% Out Power ∞, OΩ … open or short Abnormal Measure resistance between red wire and each terminal. Normal Approx. 300Ω at ambient temperature (20°C ~30°C) ∞, OΩ … open or short Abnormal Samsung Electronics...
$ When pressing the button appear on the display, select one of them. % When pressing the button appear on the display, select one of them. ^ When pressing the button appear on the display, select one of them. 5-10 Samsung Electronics...
Page 36
If all lamps of indoor unit are flickering, Plug out and plug in again and pressing ON/OFF key to retry. If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is set up for it’s model. Samsung Electronics 5-11...
Page 37
Troubleshooting <Table of the option code> MODEL OPTION CODE MC18AC2-09 020000-10021D MC19AC2-07 020000-1000D9 MC19AC2-12 020000-100340 MC24AC2-12 020000-100340 5-12 Samsung Electronics...
6. Exploded Views and Parts List 6-1 Indoor Unit 20-6 20-6-1 20-1 20-4 20-5 20-3 20-2 13-2 13-3 13-4 13-1 You can search for the updated part code number through the ITSELF. URL : http://itself.sec.samsung.co.kr Samsung Electronics...
Page 40
Exploded Views and Parts List Parts List Q’TY CODE NO Description Remark MC18AC2-09 MC19AC2-12 MC19AC2-07 MC24AC2-12 DB64-00354A GRILLE-AIR INLET DB63-00064A GUARD-AIR FILTER DB95-00287G ASS´Y-CLEANER FILTER DB63-00067A COVER-TERMINAL DB92-00248A ASSY PANEL-FRONT DB67-00051A SPACER-EVAP LOW DB67-00032A SPACER-EVAP UP DB63-00083A COVER U-BEND DB94-00040F...