Related Manuals for Toro 04480
Summary of Contents for Toro 04480
- Page 1 FORM NO. 3318-306 GB Rev A MODEL NO. 04480—60001 & UP OPERATOR’S MODEL NO. 04481—60001 & UP MANUAL ® 8- & 11-BLADE CUTTING UNITS ® (For Greensmaster 3200) © The TORO Company—1995...
-
Page 2: Table Of Contents
Table of Contents Page SPECIFICATIONS Cutting Unit Daily Adjustments ADJUSTING THE CUTTING UNIT LUBRICATION Adjusting The bedknife To The Reel Greasing Bearings And Bushings Leveling Front Roller To The Reel BACKLAPPING THE CUTTING UNIT Adjusting Height-of-Cut Specifications Height-of-Cut: The cutting height is adjusted on rear each end of the bed bar are used to level and regulate the bedknife-to-reel contact. -
Page 3: Adjusting The Cutting Unit
Refer to the Toro Reel Sharpening Manual, Form No. 80-300PT. -
Page 4: Leveling Front Roller To The Reel
Adjusting Cutting Unit LEVELING THE FRONT ROLLER screw on L.H. bracket with another eccentric bolt, part no. 93-2573. TO THE REEL (Fig. 3) Note: There are two positions for the front roller Position the cutting unit on a flat, level surface. brackets. -
Page 5: Cutting Unit Daily Adjustments
Adjusting the Cutting Unit surement is from the bar face to the underside of reel edges will not sufficiently self-sharpen and dull the screw head. cutting edges will result after a period of operation. If excessive contact is maintained, bedknife/reel Place the bar across the front and rear rollers and wear will accelerate, uneven wear can result, and adjust the height-of-cut knob until the underside... -
Page 6: Backlapping The Cutting Unit
Note: Additional instructions and procedures on back- personal injury. lapping are available in the TORO Sharpening Reel & Rotary Mowers Manual Form No. 80-300PT. Position the machine on a clean, level surface,... - Page 7 ? @ e 7 @ ( Y e W & @ ) X ? e W & @ @ @ U e V ' @ 1 e @ ? Where a warrantable condition exists, Toro will repair the Product at no cost to you including diagnosis, ? @ e @ @ H ? ? W .