Advertisement
Quick Links
Weather Protection Kit
Groundsmaster
with Security Cage
Model No. 03626
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
Perform the following procedure to prepare the mower
for attaching the blower and finishing kit.
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the machine, remove the key, and wait
for all movement to stop before leaving the
operating position.
3.
Clean the surfaces of the cage where the hoop
and hook closure will adhered to with alcohol
wipes.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
4300 or Reelmaster
Description
No parts required
Clasp
Clasp mount
Screw
Nut
Left door cover
Right door cover
Right cover
Left cover
Lower left cover
Lower right cover
Rear cage cover
Register at www.Toro.com.
Form No. 3434-151 Rev A
®
5010 Series Traction Unit
Installation Instructions
Qty.
–
Prepare the machine.
4
8
Install the clasps.
8
8
1
Install the large covers.
1
1
1
1
Install the small covers.
1
1
Original Instructions (EN)
All Rights Reserved *3434-151* A
Printed in the USA
Use
Advertisement
Related Manuals for Toro 03626
Summary of Contents for Toro 03626
- Page 1 Form No. 3434-151 Rev A Weather Protection Kit Groundsmaster ® 4300 or Reelmaster ® 5010 Series Traction Unit with Security Cage Model No. 03626 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. –...
- Page 2 Install the clasps as shown in Figure Installing the Clasps Parts needed for this procedure: Clasp Clasp mount Screw Procedure Measure the location to install the clasps on each door as shown in Figure g295829 Figure 2 1. Bolt 3. Clasp mount 2.
- Page 3 Remove half of the hoop and hook closure straps, with the adhesive, from each door cover (Figure Peal the film off of the adhesive and place it in the position for each door (Figure Install the covers for the doors by aligning the holes with the clasps and press the hoop and hook closure straps together around each door.
- Page 4 Installing the Small Covers Parts needed for this procedure: Right cover Left cover Lower left cover Lower right cover Rear cage cover Procedure Note: For the small covers, do not separate the hoop and hook closure straps. Use the whole cover for positioning.