Do not install propellers on the aircraft during installation and testing。 Thanks for purchasing RadioLink flight controller Byme-D. To fully enjoy the benefits of this product and ensure safety, please read the introduction carefully and set up the device as described below. If any problems found during the operation process, please kindly refer to the manual first or send questions to after_service@radiolink.com.cn...
Introduction About Byme-D Byme-D is applicable to all model airplanes with mix elevator/aileron controls including delta wing, paper plane, SU27, F22 and is SBUS and PPM signal supported. There are three flight modes: Stabilize Mode, Acrobat Mode and Manual Mode.
Make sure the servo phase adjustment button on Byme-D points to the aircraft head, and the pin end of Byme-D points to the tail of the aircraft. The flight controller can be installed either face up or down with 3M glue on the aircraft body and the wires connect to the corresponding pins.
Therefore, only transmitter with 7 channels or more is available. 2. You cannot set any mixing function in the transmitter when Byme-D is mounted on the aircraft. Because there is already the mixing function in Byme-D. The mix control will automatically take effects according to the flight mode of the aircraft.
Radiolink Electronic Ltd www.radiolink.com Power-On Calibration When the aircraft is powered on, the gyro on Byme-D will calibrate with the green led flashing. Please keep the aircraft remain still until the green light is always on. Attitude Calibration The flight controller needs to calibrate the attitudes/level to ensure the balanced status.
When the movement direction of the aileron is inconsistent with the joystick, please adjust the servo phase through the buttons on the front of Byme-D. Please do not change any settings of servo direction on the remote control at this time.
Radiolink Electronic Ltd www.radiolink.com Press the button at the front of Byme-D to change the servo phase: Short press once, aileron mix control reversed, LED1 ON/OFF. Short press twice, elevator mix control reversed, LED2 ON/OFF. Note: Make sure attitude calibration is complete before changing the servo phases.
Radiolink Electronic Ltd www.radiolink.com Gyro Mode The model rotation is controlled by joysticks with gyro increasing the stability. This is an advanced mode. The model won’t level but and keeps rotating when joystick is loose. Radiolink Electronic Ltd www.radiolink.com...
Radiolink Electronic Ltd www.radiolink.com Manual Mode Pilots control servos with corresponding channels by transmitter, neither attitude nor gyro involved. Motor Safety Lock The lock can be turned on/off by CH7 (2-way switch) of the transmitter. Radiolink Electronic Ltd www.radiolink.com...
Radiolink Electronic Ltd www.radiolink.com Gyro Sensitivity There is certain stability margin for the Byme-D PID control. To different models, if Byme-D under correct or over correct, pilots can try adjusting the rudder angle. Radiolink Electronic Ltd www.radiolink.com...