Page 1
(มี ค ำแนะนำการติ ด ตั ้ ง ให้ ม าด้ ว ย) ....................... 12 - 21 Thank you for purchasing the Panasonic Electric Home Shower. For optimum performance and safety, please carefully read this Operating Instructions and keep this documentation in a safe place for future reference.
CONTENTS Page No. BEFORE USING ELECTRIC HOME SHOWER 1. SAFETY INSTRUCTIONS 2. PARTS IDENTIFICATION 3. ACCESSORIES HOW TO USE ELECTRIC HOME SHOWER 1. HOW TO USE 2. WATER FLOW RATE ADJUSTMENT 3. MAINTENANCE 4. TROUBLESHOOTING 5. SPECIFICATIONS HOW TO INSTALL ELECTRIC HOME SHOWER 1.
Page 3
High High ELB Test ELB Test ELB Reset ELB Reset Push Up Push Up DH-3PL1 DH-3PL1 electric shock hazards. • Pay attention to the shower temperature when FILTER FILTER CLEANING CLEANING reducing the volume of water. The shower temperature will become very hot if the water flow rate is too low.
2. PARTS IDENTIFICATION ON/OFF DP (double pole) Switch Built in Earth Leakage Breaker (ELB) Bath Room Earth Parts not included Flexible Cord (Not included) Water Volume Knob Miniature Circuit Breaker (MCB) Back Plate Adjust Holder Front Plate ELB Lamp OF F MA X Shower Head FILTER...
2. Switch on the Miniature Circuit Breaker (MCB) and ON/OFF DP (double pole) Switch. ELB Reset Push Up DH-3PL1 ELB: On condition 3. Push up the ELB Reset Lever if it is down. 4. Turn the Main Switch Knob to "On" (ELB Lamp will light).
Dismantle, cleaning and assemble of Filter Unit Close the Main Water Valve. Turn the Filter Knob anticlockwise and pull it out. High Water Volume Knob ELB Test ELB Reset Push Up DH-3PL1 Filter Knob FILTER FILTER CLEANING CLEANING Main Water Valve Clean the Filter Unit.
3) Water temperature cannot be controlled. 4) ELB lamp does not light up. (3) Special skill is required for repairing. Never try to repair the Unit by yourself. 5. SPECIFICATIONS Model No DH-3PL1 DH-4PL1 Voltage 220 V a.c. 50 Hz Electric Power Control Inlet Water Temp.
WARNING High ELB Test During installation process make sure electric and ELB Reset Push Up DH-3PL1 water supply is turn "OFF". FILTER CLEANING 1.5 m ~ 1.7 m 1. Where to install the Unit. • Be sure to install the Unit on the wall as illustrated in Figure 1 (vertical position with the water fittings pointing downward).
Page 9
3. How to fix Electric Home Shower. 1 The distance of the Unit should be more than 250 mm 2 Make 4 holes at the wall by means of a drill. from right and left of the wall. 3 Drive a Wall Plug into the hole. 98.5 mm 25 mm Wall Plug...
Page 10
4 Earth Rod WARNING The Unit must be earthed. Improper grounding could cause electric shock. • The Unit must be earthed. • Earth Rod fixing procedure. Select suitable place to bury the optional Earth Rod (DQ-6H) for at least 70 cm below ground surface. •...
• It is normal if the ELB turns “Off” (the ELB Reset Lever falls) and push the ELB Reset Lever up. ELB Test Refer figure as shown. ELB Reset Push Up DH-3PL1 • Inspection on the built-in ELB (once a month) to avoid a hazard to users such as damage to property, serious injury or death. FILTER Reset Lever...