Advertisement
Quick Links
Skid Plate Kit
Groundsmaster
Model No. 136-4360
This product contains a chemical or chemicals known to the State of California to
Installation
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Lower the cutting units.
3. Engage the parking brake.
4. Shut off the engine and remove the key.
5. Use a jack to raise the machine.
Note: There are jacking points located at the front
and rear of the machine; refer to the Operator's Manual
for your machine.
DANGER
Mechanical or hydraulic jacks may fail to support
machine and cause a serious injury.
• Use jack stands when supporting machine.
• Do not use hydraulic jacks.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
4000 or 4100 Series Rotary Mower
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Register at www.Toro.com.
2
Installing the Skid Plates
Parts needed for this procedure:
2
Outer-rear skid plate
1
Rear skid plate
2
Front skid plate
4
Lock washer
4
Hex-socket screw
4
Spring-coil washer
4
Bolt (M10 x 30 mm)
4
Bolt (3/8-16 x 4 inches)
4
Flange nut
Installing the Rear Skid Plates
1. Remove the existing hardware (4 bolts and 4 washers)
from the mount plate as shown in
Original Instructions (EN)
All Rights Reserved *3413-386* A
Printed in the USA.
Form No. 3413-386 Rev A
Installation Instructions
Figure
1.
Advertisement
Related Manuals for Toro 136-4360
Summary of Contents for Toro 136-4360
- Page 1 Form No. 3413-386 Rev A Skid Plate Kit Groundsmaster ® 4000 or 4100 Series Rotary Mower Model No. 136-4360 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 g207711 g204660 Figure 3 Figure 1 Right Side Shown 1. Bolt—existing hardware 2. Washer—existing hardware 1. Bolt 3. Axle 2. Axle cap 2. Use 4 bolts (M10 x 30 mm) and 4 spring-coil washers to secure the rear skid plate to the mount plate (Figure 4.
- Page 3 Installing the Front Skid Plates 1. Remove the existing hardware (2 bolts and 2 nuts) from the manifold on the left side of the machine (Figure g205111 Figure 5 Left Side Shown 1. Bolt—existing hardware 5. Bolt (3/8-16 x 4 inches) 2.
- Page 4 4. Repeat steps through to install the other front skid plate to the right side of the machine (Figure g205112 Figure 6 Right Side Shown 1. Bolt—existing hardware 5. Bolt (3/8-16 x 4 inches) 2. Manifold 6. Front skid plate 3.