Advertisement
Quick Links
Traction Pedal Improvement Kit
Groundsmaster
315000001 through 316999999
Model No. 136-4450
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note: Install this kit for improving the movement of the machine out of neutral position.
This product contains a chemical or chemicals known to the State of California to
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
360 Multi-Purpose Machine with Serial Number
Description
Thrust washer
Sleeve spacer (long)
Sleeve spacer (small)
Bearings
Traction rod
Jam nut (3/8 inch)
Rod-end bearing
Linkage plate
Rubber mount
Plastic mount
No parts required
No parts required
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Register at www.Toro.com.
Qty.
1
1
1
2
1
1
1
1
2
2
–
–
WARNING
CALIFORNIA
Form No. 3412-991 Rev A
Installation Instructions
Use
Install the traction rod.
Install the traction rod.
Adjust the traction rod.
Adjust the traction drive for neutral.
Original Instructions (EN)
All Rights Reserved *3412-991* A
Printed in the USA
Advertisement
Related Manuals for Toro Groundsmaster 136-4450
Summary of Contents for Toro Groundsmaster 136-4450
- Page 1 CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. © 2017—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3412-991* A...
- Page 2 Installing the Traction Rod Parts needed for this procedure: Thrust washer Sleeve spacer (long) Sleeve spacer (small) Bearings g200733 Figure 2 1. Sleeve spacer (long) 3. Sleeve spacer (small) Procedure 2. Bearings 4. Neutral-arm assembly 1. Park the machine on a level surface, shut off the engine, engage the parking brake, and remove the key from 6.
- Page 3 Installing the Traction Rod Parts needed for this procedure: Traction rod Jam nut (3/8 inch) Rod-end bearing Linkage plate Rubber mount Plastic mount Procedure g200734 1. Locate and remove the traction-lever arm (Figure Figure 5 1. Traction rod 3. Install the rod-end bearing and jam nut onto the traction rod (Figure 4.
- Page 4 g200729 Figure 6 1. Traction rod 5. Rubber mount 2. Jam nut 6. Traction-lever arm 3. Rod-end bearing 7. Plastic mount 4. Linkage plate 8. Plastic washer is only used with the plastic mount Adjusting the Traction Rod No Parts Required Procedure 1.
-
Page 5: Adjusting The Traction Drive For Neutral
• If the left rear tire is rotating, loosen the jam nuts on the left side transmission control rod (Figure Note: The forward end of the control rod has a left-hand thread. The rear end of the rod, which is connected to the transmission, has a right-hand thread. - Page 6 Notes:...
- Page 7 Notes:...