Table of Contents
Advertisement
3
To execute the load, select "Execute,"
then press the SEL/SET button or jog
dial.
To cancel the load, select "Cancel," then
press the SEL/SET button or jog dial.
If you select "Execute," a list box of lens files
appears. File numbers where "No File" is
displayed are empty file numbers.
4
Select the desired file number, then
press the SEL/SET button or jog dial.
A confirmation message appears.
5
To execute the load, select "Execute,"
then press the SEL/SET button or jog
dial.
To cancel the load, select "Cancel," then
press the SEL/SET button or jog dial.
If you selected "Recall SxS" in step 2, the
ACCESS lamp lights in red when you
execute the load.
When the specified lens file has been loaded
from the SxS memory card, a completion
message appears and the ACCESS lamp goes
out, or lights in green.
Loading Lens Files Automatically
When you are using a lens that supports serial
communication, you can set up the camcorder by
automatically loading the lens file that
corresponds to the lens settings (Lens Auto Recall
function).
To use the Lens Auto Recall function, set "LENS
File" > "Auto Recall" in the setup menu to one of
the following.
Off: Do not use the Lens Auto Recall function.
On (Lens Name): Load the lens file that
corresponds to the model name.
On (Serial Number): Load the lens file that
corresponds to the model name and serial
number (when the lens supports
communication of the serial number).
If the lens does not support communication of the
serial number, either "On" setting above will load
the lens file that corresponds to the model name
only.
Backup Battery
Replacement
This camcorder uses a backup battery to retain
various setting data.
A lithium battery (CR2032) for backup is
mounted in the camcorder at the factory.
The backup battery retains the date, time, and
timecode in Free Run mode even when no
operating power is being supplied.
Service life of the backup battery
When the backup battery's voltage falls, the
backup battery low-voltage warning appears on
the viewfinder screen.
If this warning appears, replace the battery as
soon as possible.
WARNING
• Battery may explode if mistreated. Do not
recharge, disassemble, or dispose of in fire.
• Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer.
When you dispose of the battery, you must obey
the law in the relative area or country.
Replacing the backup battery
Notes
• Be sure to set the power switch to OFF when replacing
the backup battery.
• Be careful not to drop the removed screw into the
camcorder.
1
Remove the screw of the backup battery
holder (page 13), then remove the cover.
Insert a nonmetalic item, such as a
plastic toothpick, to the side of the
battery and lever the battery out of its
compartment.
The backup battery holder is exposed when
the breast pad is pulled out.
Backup Battery Replacement
131
Hide quick links:
Advertisement
Table of Contents
