Page 1
Canadian Model AEP Model E Model Australian Model STR-DE335 Chinese Model STR-V323 Photo: STR-DE335 US model SPECIFICATIONS Audio power specifications (US model) Reference power: STR-SE391 (8 ohms at 20 Hz – 20 kHz, (8 ohms at 1 kHz, POWER OUTPUT AND TOTAL HAR- less than 0.09 % total...
Page 2
VIDEO 430 × 144 × 306 mm 531 – 1602 kHz (9 kHz step) Dimensions Antenna Loop antenna Mass (Approx.) STR-DE335: US model Outputs MD/TAPE REC OUT: Intermediate 450 kHz 8.7 kg Voltage: 150 mV, (US, AEP frequency STR-DE335: AEP model...
SONY PARTS WHOSE PART NUMBERS APPEAR AS DE FONCTIONNEMENT. NE REMPLACER CES COM- SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- POSANTS QUE PAR DES PIÈCES SONY DONT LES LISHED BY SONY. NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
SECTION 1 SERVICING NOTES MODEL IDENTIFICATION SAFETY CHECK-OUT After correcting the original service problem, perform the follow- – Rear view – ing safety check before releasing the set to the customer: Check the antenna terminals, metal trim, “metallized” knobs, screws, and all other exposed metal parts for AC leakage. Check leakage as described below.
SECTION 3 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. CASE 1 screw 1 two screws (case 3 TP2) (case 3 TP2) 2 case 1 two screws (case 3 TP2) FRONT PANEL SECTION 3 screw (BVTP3 × 8) 1 flat wire (CNS503) 2 three connectors...
SECTION 4 TEST MODE Initialization Mode All preset contents are cleared when this mode is activated. When returning the unit to the customer after completing repairs, per- form this operation to clear the unit. Procedure: [TUNER] [MD/TAPE] 1. While pressing two buttons of multaneously, press the button to turn the power ON.
VIDEO FCR-IN (Page 11) MUTE MUTING VIDEO OUT TV/LD Q363 FCLS-IN VIDEO IN S-RCH LINE AMP REAR RS-OUT IC502 STR-DE335: AEP, E, Malaysia, –2 FCRS-IN (Page 11) Singapore/STR-V323 MUTING Q364 CENTER J252 (1/2) IC MUTE LC-INB VIDEO RV421 RV422 RV423...
Page 11
BASS BOOST BASS BOOST FILTER AMP SWITCH SPEAKERS FRONT Q452 Q401 IMPEDANCE USE 8 – 16Ω POWER AMP – S701–2–2 IC702 (1/2) (EXCEPT STR-DE335: AEP) S701–3–1 +VOUT1 –2 FINAL SPEAKERS FRONT DRIVER DRIVER –VOUT1 DRIVE IMPEDANCE (Page 10) BIAS Q753, 754 USE 4 –...
5-4. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS • Waveforms – MAIN Board – – DISPLAY Board – Note on Printed Wiring Board: Note on Schematic Diagram: • X : parts extracted from the component side. • All capacitors are in µF unless otherwise noted. pF: µµF 1 IC1 !£...
Page 14
• Circuit Boards Location SECONDARY board VOL SEL board (DE335:E) PRIMARY board DISPLAY board STANDBY board REAR AMP board VIDEO board PHONO board (SE391) POWER SWITCH board SP SW board MAIN board KEY board VOLUME board TONE board – 19 –...
STR-DE335/SE391/V323 5-7. SCHEMATIC DIAGRAM – MAIN Board (1/4)/REAR AMP Board – • See page 42 for IC Block Diagrams. (Page 39) (Page 39) (Page (Page 27) (Page 40) The components identified by Les composants identifiés par une mark ! or dotted line with marque ! sont critiques pour la mark ! are critical for safety.
STR-DE335/SE391/V323 5-8. SCHEMATIC DIAGRAM – MAIN Board (2/4)/SP SW Board – (Page 26) (Page 31) The components identified by Les composants identifiés par une mark ! or dotted line with marque ! sont critiques pour la mark ! are critical for safety.
Page 19
STR-DE335/SE391/V323 5-9. SCHEMATIC DIAGRAM – MAIN Board (3/4) – • See page 18 for Waveforms. • See page 41 for IC Block Diagrams. (Page 26) (Page 39) (Page 31) (Page 39) (Page 35) – 29 – – 30 –...
STR-DE335/SE391/V323 5-10. SCHEMATIC DIAGRAM – MAIN Board (4/4)/SECONDARY Board/STANDBY Board/PRIMARY Board/VOL SEL Board – • See page 43 for IC Block Diagram. (Page 27) (Page 30) The components identified by Les composants identifiés par une mark ! or dotted line with marque ! sont critiques pour la mark ! are critical for safety.
STR-DE335/SE391/V323 5-12. SCHEMATIC DIAGRAM – PANEL Section – • • See page 18 for Waveform. See page 43 for IC Block Diagram. EXCEPT DE335: MY,SP,AUS/ V323 (Page 29) EXCEPT DE335: MY,SP,AUS/ V323 (Page 39) The components identified by Les composants identifiés par une...
Power supply terminal (+5V) (for A/D converter analog system) AVREF Reference voltage (+5V) input terminal (for A/D converter) RDS data input from the RDS decoder (IC1) (Used for the STR-DE335 AEP model only) RDS DATA IN Except STR-DE335 AEP model: Not used (fixed at “L”) OPEN —...
Page 28
RDS serial clock signal input from the RDS decoder (IC1) RDS CLK IN (Used for the STR-DE335 AEP model only) Except STR-DE335 AEP model: Not used (fixed at “L”) Power down detection signal input from the reset signal generator (IC950) STOP “L”: power down, normally: “H”...
SECTION 6 EXPLODED VIEWS NOTE: • -XX and -X mean standardized parts, so they • Items marked “*” are not stocked since they The components identified by mark ! or dotted line with mark may have some difference from the original are seldom required for routine service.
SECTION 7 DISPLAY ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they The components identified by mark ! or dotted line with mark are seldom required for routine service. parts list may be different from the parts speci- ! are critical for safety.
Page 43
TONE VIDEO VOL SEL VOLUME Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R474 1-247-903-00 CARBON 1/4W J251 1-770-336-11 JACK, PIN 2P (5.1CH/DVD VIDEO, TV/LD VIDEO IN) (DE335: AEP) < VARIABLE RESISTOR > J252 1-774-821-11 JACK, PIN 3P (VIDEO IN/OUT, MONITOR VIDEO OUT) (DE335/V323) RV421 1-223-362-11 RES, VAR, CARBON 100K/100K (BASS)
Page 44
Ver 1.1 2001.07 VOLUME Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 0 T901 C426 1-126-795-11 ELECT 10uF 1-433-713-21 TRANSFORMER, POWER (SE391) 0 T901 C430 1-104-942-11 ELECT 1-433-714-11 TRANSFORMER, POWER (DE335: CND) C431 1-104-942-11 ELECT 0 T901 1-433-715-11 TRANSFORMER, POWER (DE335: AUS) 0 T901 C440...
Page 45
STR-DE335/SE391/V323 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2001.07...