HP AdvanceStack 10Base-T Quick Setup Manual
Hide thumbs
Also See for AdvanceStack 10Base-T:
- Manual (194 pages) ,
- Installation and reference manual (138 pages) ,
- Installation manual (54 pages)
Advertisement
Quick Links
Quick Setup Guide
for the HP AdvanceStack 10Base-T Hubs
Installation details are provided in the HP AdvanceStack 10Base-T Hubs Installation and
Reference Guide (5963-6554).
ThinLAN
network
port
AdvanceStack HP J2600A
Thin LAN
chain ports
power
connector
1. Install optional add-in modules, for example an
HP Ethernet SNMP Module into the Expansion
Slot.
2. Plug the power cord into the hub's receptacle
and into a properly grounded electrical outlet.
The hub does not have a power switch; it is
powered on when the power cord is plugged in.
hub status LEDs
and reset button
Reset
Exp Slot
Security
Activity
Power
ThinLAN
Console
AUI/Xcvr
Collision
Fault
Distributed Management
Extension
RS-232
AUI/Xcvr
Slot
In Out
RS-232
console port
redundant power
Install the Hub
twisted-pair port LEDs
12
11
10
9
8
7
optional AUI port module
installed in AUI/Xcvr slot
slot for HP Ethernet SNMP Module
connector
HP Ethernet SNMP Module
Power receptacle on
the back of the hub
6
5
4
3
2
1
10Base-T
Hub-12
cable management
cover plate over
guide
Advertisement
Related Manuals for HP AdvanceStack 10Base-T
Summary of Contents for HP AdvanceStack 10Base-T
-
Page 1: Quick Setup Guide
Quick Setup Guide for the HP AdvanceStack 10Base-T Hubs Installation details are provided in the HP AdvanceStack 10Base-T Hubs Installation and Reference Guide (5963-6554). hub status LEDs ThinLAN and reset button twisted-pair port LEDs network port Reset Exp Slot Security... - Page 2 3. Check the LEDs on the hub’s front panel. When the hub is powered on, it performs a 3 to 60 second self-diagnostic test. When the test completes, the following occurs: Status LEDs – Power LED is on. – RPS LED is on if a Redundant Power Supply is connected (available at the end of 1995).
- Page 3 Hub-to-Hub Connections 1. To connect the hub to another hub, push the “crossover” cable RJ-45 plug into the RJ-45 jack until the tab on the plug clicks into place. 2. Push the other end of the cable into the connecting hub. twisted-pair “crossover”...
- Page 4 © 1995 Hewlett-Packard Company HP Part Number: 5963-6555 Edition 1, July 1995 Printed in Singapore *5963-6555*...