Advertisement
Quick Links
49-407.fm Page 1 Friday, May 26, 2000 2:26 PM
Self-Stick Door/Window Alarm
Your RadioShack Self-Stick Door/Window Alarm is a
convenient and easy-to-use security device. You
can easily install the alarm on almost any smooth
door surface or glass window. If the alarm senses an
abrupt shock or vibration, it sounds a 120-dB alarm
to warn you and scare off possible intruders.
Its features include:
Selectable Sensitivity Switch — lets you set the
alarm's sensitivity higher or lower.
Red Warning Label — can be seen through window
to show that your home is protected.
Automatic Reset — automatically reset the alarm in
about 30 seconds after the alarm is activated.
Intruder Memory Indicator — warns you that the
alarm has been activated.
PREPARATION
Installing the Battery
The alarm requires a 9V battery for power (not sup-
plied, available at your local RadioShack store).
Caution: Use only a fresh battery of the required
size and recommended type.
Follow these steps to install the battery:
1. Use a Philips screwdriver to loosen the screw in
the battery compartment and slide off the cover.
2. Snap a 9V battery into the connector in the bat-
tery compartment and place the battery in the
compartment.
3. Replace the cover and secure it with the screw.
Warning: Dispose of old batteries promptly and
properly. Do not burn or bury them.
Caution: If you do not plan to use the alarm for a
month or more, remove the battery. Batteries can
leak chemicals that can destroy electronic parts.
Note: When the green low battery indicator flashes,
replace the battery.
OWNER'S MANUAL — Please read before using this equipment.
Installing the Alarm
Choose a smooth, clean mounting surface, then
peel off the protective film on the back of the alarm
and firmly press the alarm against the surface.
OPERATION
Warning: The alarm is very loud. Prolonged expo-
sure to the siren in an enclosed area may cause per-
manent hearing impairment or loss.
1. To turn on the alarm, slide the cover at the upper
front of the alarm upward, then turn
. The red indicator flashes once.
ON
2. Select the alarm's sensitivity by sliding
to
or
HI
LOW
shock or vibration, it sounds a 120-dB alarm for
about 30 seconds. The red indicator lights and
remains lit to warn you that the alarm has been
activated.
Notes:
• If the alarm is triggered again within two min-
utes of the first alarm and while the intruder
light is still on, the subsequent alarms may be
shorter than 30 seconds.
• To reset the intruder memory indicator, simply
turn alarm off, then on.
CARE
To enjoy your RadioShack Self-Stick Door/Window
Alarm for a long time:
• Keep the alarm dry. If it gets wet, wipe it dry
immediately.
• Use and store the alarm only in normal tempera-
ture environments.
• Handle the alarm gently and carefully. Do not
drop it.
• Keep the alarm away from dust and dirt.
• Wipe the alarm with a damp cloth occasionally
to keep it looking new.
©
2000 Tandy Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by Tandy Corporation.
ON OFF
. When the alarm senses an abrupt
to
HI/LOW
Advertisement
Related Manuals for Radio Shack Self-Stick Door/Window Alarm
Summary of Contents for Radio Shack Self-Stick Door/Window Alarm
- Page 1 49-407.fm Page 1 Friday, May 26, 2000 2:26 PM Self-Stick Door/Window Alarm OWNER’S MANUAL — Please read before using this equipment. Your RadioShack Self-Stick Door/Window Alarm is a Installing the Alarm convenient and easy-to-use security device. You Choose a smooth, clean mounting surface, then...
-
Page 2: Specifications
49-407.fm Page 2 Friday, May 26, 2000 2:26 PM Modifying or tampering with the alarm’s internal components can cause a malfunction and might invalidate its warranty. If your alarm is not performing as it should, take it to your local RadioShack store for assistance. SPECIFICATIONS Power Source ...............................