Related Manuals for Fujitsu D2530
Summary of Contents for Fujitsu D2530
- Page 1 PRIMERGY Susanne Däschlein Fujitsu Siemens Computers GmbH München 81730 München e-mail: email: manuals@fujitsu-siemens.com Tel.: (089) 61001-155 Fax: (++49) 700 / 372 00000 D2530 (Econel 200 S2) Sprachen: En...
- Page 2 Gesellschaft für Technik-Dokumentation mbH www.cognitas.de Copyright and Trademarks Copyright © 2006 Fujitsu Siemens Computers GmbH. All rights reserved. Delivery subject to availability; right of technical modifications reserved. All hardware and software names used are trademarks of their respective manufacturers.
-
Page 3: Table Of Contents
Replacing the lithium battery ....25 Abbreviations ....... 27 Technical Manual D2530 (Econel 200 S2) -
Page 5: Introduction
Introduction This technical manual describes the system board D2530, which can be ® equipped with one or two Intel processors. Further information about drivers is provided in the readme files on the hard disk, on the supplied "ServerSupport" or "ServerStart" CDs. -
Page 7: Important Notes
Information on which system expansions are suitable can be obtained from the customer service centre or your sales outlet. The warranty expires if the device is damaged during the installation or replacement of system expansions. Technical Manual D2530 (Econel 200 S2) - Page 8 Incorrect replacement of lithium battery may lead to a risk of explosion. The batteries may only be replaced with identical batteries or with a type recommended by the manufacturer. It is essential to observe the instructions in chapter “Replacing the lithium battery”. Technical Manual D2530 (Econel 200 S2)
- Page 9 Place all components on a static-safe base. You will find a detailed description for handling ESD components in the relevant European or international standards (EN 61340-5-1, ANSI/ESD S20.20). Technical Manual D2530 (Econel 200 S2)
-
Page 10: Ce Certificate
Never use sharp objects (screwdrivers) for leverage. CE Certificate The shipped version of this board complies with the requirements of the EEC directive 89/336/EEC "Electromagnetic compatibility". Compliance was tested in a typical PRIMERGY configuration. Technical Manual D2530 (Econel 200 S2) -
Page 11: Environmental Protection
Cd Cadmium Hg Mercury Pb Lead Notes on labeling plastic housing parts Please avoid attaching your own labels to plastic housing parts wherever possible, since this makes it difficult to recycle them. Technical Manual D2530 (Econel 200 S2) - Page 12 You will find further information on this at www.fujitsu- siemens.com/recycling. For details on returning and reuse of devices and consumables within Europe, refer to the “Returning used devices” manual, or contact your Fujitsu Siemens Computers branch office/subsidiary or our recycling centre in Paderborn: Fujitsu Siemens Computers...
-
Page 13: Features
ES1000) onboard with 32 MB RAM memory – 1 MBYTE Flash EPROM für: – System BIOS – Onboard Video – Onboard LAN – Onboard LSI Software RAID – Onboard SATA – system management controller (temperature, voltages, fans) W83793G Technical Manual D2530 (Econel 200 S2) - Page 14 – 1 x PCI 33 MHz – 1 x PCI-Express x16 slot (x8 wired) – 1 x PCI-Express x8 slot (x4 wired) BIOS features – AMI (American Megatrend BIOS) Form factor 12“ x 10.5“ Technical Manual D2530 (Econel 200 S2)
-
Page 15: Main Memory
512 Mbyte modules and pair 1A/1B with two 1 Gbyte modules. Following table shows the mandatory population order: DIMM 1A DIMM 2A DIMM 1B DIMM 2B single channel populated empty empty empty dual channel populated empty populated empty populated populated populated populated Technical Manual D2530 (Econel 200 S2) -
Page 16: Pci Bus
Multifunctional PCI boards or boards with an integrated PCI-to-PCI bridge can use several PCI interrupts (INTA#, INTB#, INTC#, INTD#). Monofunctional PCI boards (default) only use one PCI interrupt (INTA#) per PCI slot. Technical Manual D2530 (Econel 200 S2) - Page 17 PIRQC PIRQD Slot 5 PCI-Express Slot 6 PCI-Express PIRQB PIRQE USB UHCI PIRQA Controller #0 USB UHCI PIRQD Controller #1 USB UHCI PIRQC Controller #2 USB UHCI PIRQA Controller #3 USB 2.0 EHCI PIRQH Technical Manual D2530 (Econel 200 S2)
-
Page 18: Screen Resolution
Temperature monitoring Measurement of the processor temperature, measurement of the ambient temperature by a temperature sensor on the LED board. Fan monitoring Fans that are no longer available, blocked or sticky fans are detected. Technical Manual D2530 (Econel 200 S2) - Page 19 However, this will only be indicated when the system is switched on again System Event Log (SEL) All monitored events of the system board are recorded in the System Event Log. They could be retrieved after a system reboot via ServerView. Technical Manual D2530 (Econel 200 S2)
-
Page 20: Connectors And Jumpers
PCI-E x8 PCI 33MHz PCI-X 133/100 MHz PCI-X 133/100 MHz PCI-X 133/100 MHz Figure 4: Schematic overview of the system board D2530 1 = KBPWR (jumper) 15 = USBPW 3/4 (jumper) 2 = USBPW 1/2 (jumper) 16 = USB 3/4... - Page 21 BIOS (default) recover system BIOS (Flash BIOS, Recovery Diskette required) VGA_EN (22) onboard VGA enabled (default) onboard VGA disabled (PCI VGA graphics controller) CLRTC (23) CMOS/RTC settings are not cleared (default) clear CMOS/RTC settings Technical Manual D2530 (Econel 200 S2)
-
Page 22: External Connectors
AC loss or system board not connected to power supply unit 3.6.1 External connectors Figure 5: External connectors of the system board D2530 1 = PS/2 mouse port 4 = Serial port COM1 2 = PS/2 keyboard port... - Page 23 LAN link/activity green LAN connection no LAN connection flashing LAN transfer LAN transfer rate green + orange off transfer rate 10 Mbit/s (or no connection) green transfer rate 100 Mbit/s orange transfer rate 1000 Mbit/s Technical Manual D2530 (Econel 200 S2)
-
Page 25: Replacing The Lithium Battery
Ê Press the locking spring into direction of of the arrow (1), so that the lithium- battery jumps out of its socket. Ê Remove the battery (2). Ê Insert a new lithium battery of the same type into the socket (3) and (4). Technical Manual D2530 (Econel 200 S2) -
Page 27: Abbreviations
American National Standards Institute ASR&R Automatic Server Recovery and Restart Advanced Technology Attachment Battery Backup Unit BIOS Basic Input Output System Baseboard Management Controller CMOS Complementary Metal Oxide Semiconductor COMmunication port Central Processing Unit Technical Manual D2530 (Econel 200 S2) - Page 28 EEPROM Electrical Erasable Programmable Read Only Memory Extensible Firmware Interface Elektrostatisch gefährdete Bauteile EHCI Enhanced Host Controller Interface Electromagnetic interference EMRL Embedded RAID Logic Elektromagnetische Verträglichkeit (electromagnetic compatibility) EPROM Erasable Programmable Read Only Memory Technical Manual D2530 (Econel 200 S2)
- Page 29 Front Side Bus In Circuit Emulation Integrated (intelligent) Drive Electronics International Electrotechnical Commission Integrated Mirroring Enhanced IOOP Intelligent Organisation Of PCI IPMB Intelligent Platform Management Bus IPMI Intelligent Platform Management Interface iRMC integrated Remote Management Controller Technical Manual D2530 (Econel 200 S2)
- Page 30 Multi Processor Specification Non Maskable Interrupt Original Equipment Manufacturer OHCI Open Host Controller Interface Operating System Peripheral Components Interconnect Prefailure Detection and Analyzing Programmed Input Output Power Distribution Board Programmable Logic Device PS(U) Power Supply (Unit) Technical Manual D2530 (Econel 200 S2)
- Page 31 RAID on Motherboard Remote Service Board ReSeT Real Time Clock Serial Attached SCSI SATA Serial ATA SCSI Small Computer Systems Interface SDDC Single Device Data Correction SDRAM Synchronous Dynamic Random Access Memory System Event Log Technical Manual D2530 (Econel 200 S2)
- Page 32 Symmetrical Multi Processing UHCI Unified Host Controller Interface Universal Serial Bus Video Graphics Adapter Voltage Regulator Down Voltage Regulator Module WEEE Waste from Electric and Electronic Equipment (EU Directive) Wired for Management Wake up On LAN Technical Manual D2530 (Econel 200 S2)
- Page 33 Comments Suggestions Corrections Fax: (++49) 700 / 372 00000 Comments on System Board D2530 for Econel 200 S2 D2530 (Econel 200 S2)
- Page 35 Information on this document On April 1, 2009, Fujitsu became the sole owner of Fujitsu Siemens Compu- ters. This new subsidiary of Fujitsu has been renamed Fujitsu Technology So- lutions. This document from the document archive refers to a product version which was released a considerable time ago or which is no longer marketed.