Advertisement
Available languages
Available languages
INSTALLATION
AND SERVICE MUST BE PERFORMED BY
A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
If the information
in this manual
is not followed
exactly, a fire or explosion
may result
causing property
damage,
personal
injury or death.
FOR YOUR SAFETY:
m
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
--
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not use any phone in your building.
•
Immediately
call your gas supplier from a neighbor's phone.
Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call the fire department.
--
Installation and service must be performed
by a qualified installer, service agency or the gas supplier.
l Additional
Safeguards
• Do not install wall oven beneath the work counter.
• The flue charge shall not be located below the 36" level.
42 3/s"
37 3/8"
8
B
H
A
Electrical
Outlet
Location for model
with
lY_ oven
/ity
Electrical
Outlet
Location
for
- model with
2
oven cavities
_-_
T _
T
27"
Model with 2 oven cavities
Model with 11/zoven cavity
Clearance for complete door opening:
• For model with 2 cavities allow at least 17 5/8".
• For model with 1Y2cavity allow at least 19 3/8".
Figure 1
Drill a lY2" diameter
hole
for gas hook up
<:xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx:_ <:xxxxxxxxxxxxxxxxxxxxxxxxx:_
Model
with
2 cavities
19 Y2" Min.
10"
Min.
Model wi_ 1 Y2 cavity
27 Y2" Max.
2 Y2" Min.
24"
Min.
16 3A"
7 1/8"
22 Y2"
24"
Min.
42 1/8"
37 Y2" Min.
1 Y2" Min.
24"
Min.
20"
7 s/8"
22"
23 Y2" Min.
39"
Max.
NOTE: Wiring diagrams for these appliances are enclosed in this booklet.
_
Recycled paper
Printed in Canada
PIN 318201550
(0003)
Rev. A
English - pages 1-8
Espa_ol - p4ginas 9-17
Wiring Diagram - pages 18-20
Advertisement
Table of Contents
Related Manuals for Frigidaire FGB557CESE
Summary of Contents for Frigidaire FGB557CESE
- Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal...
-
Page 2: Important Safety Instructions
Important Notes to the Installer Do not store items or food of interest Read all instructions contained in these installation to children in the cabinets above the appliance. instructions before installing the appliance, Children could be seriously burned or injured if they Remove all packing material and literature from the climb on the appliance to reach these items oven and broiler compartments before connecting gas... - Page 3 3. Alternate construction 2. Connect Electricity to Gas Wall Oven (Model with 11/zoven cavity only) Installation Instructions for installing a 11//2 cavity oven into For personal safety, these appliances must be an existing 2 cavity opening with dimensions 42 1/8" height properly grounded.
- Page 4 Oven 4. AdJusting Oven Height (Model with 1 1/2oven cavity only) Remove and lay aside the lower vent decorative trim that is taped to the side or to the top of the oven decorative trim will be fastened to the lower front of the oven after it has been installed in the cabinet There is a 1 Y2"...
-
Page 5: Gas Supply
B. Model With 2 Oven Cavities Insert appliance into cutout, The unit must be secured in place, Use the 2 screws provided in the miscellaneous Remove Screw_:::_ parts bag, for mounting the appliance in the mounting holes on each side trim aside the central vent trim (figure B1 Vent Pipe "]_ 4"I,D,... -
Page 6: Lp/Propane Gas Conversion
BEFORE CONNECTING THE UNIT 8. Connection to gas Remove all packing material and literature from wall A. Model with 1 Vz oven cavity (seefigure 9) oven before connecting gas and electrical supply to the appliance, Pressure Regulator If applicable, remove broiler or storage drawer by pulling drawer out to stops, Lift drawer front to clear stops and pull out, Leak testing of the appliance shall be conducted... -
Page 7: Natural Gas Conversion
Using a Y2" wrench, turn down the adjustable spud which injects gas into the oven burner. Spud SMALL End Towards approximately 2Y2 turns until snug against the LP metering pin. Do not overtighten (see figure 1 3). 10. Natural Gas Conversion Convert the Pressure Regulator for use with Natural Gas (see figure A. -
Page 8: Check Operation
Observe t he ovenburner flameto determine if it isright. Model and Serial Number Location It should besteady witha blueconeapproximately 1" The serial plate is located on the left side inner trim of andshould notextend out overtheedges of baffle. For the oven for the model with 1 Y2oven cavity and on the LP Gas, t hiswill mostlikelyoccurwhenthe air lower oven frame for the model with 2 oven cavities. - Page 9 LA INSTALACION Y EL SERVICIO DEBEN SER REALIZADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR ELI_CTRICO LOCAL. .EA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS Si todas las instrucciones de este manual no son observadas a la letra, se puede ocurrir incendios o explosiones que pueden causar dahos materiales, lesiones o la muerte.
- Page 10 Notas importantes para el instalador: encima de la estufa o en la guarda posterior de 1. Lea todas las instrucciones de instalacion antes de esta. Los nihos pueden quemarse o lastimarse realizar la instalacion de la plancha de cocinar. seriamente si se suben en la estufa para alcanzar estos 2.
-
Page 11: Conexion Electrica
2. Conexion Electrica 3. Alternativa de construccion Como medida de seguridad personal, este artefacto (Para modelo con I 1/zcavidades solamente) debe conectarse a tierra correctamente. Instrucciones para instalar un horno de 1 Y2cavidades en una abertura existente para horno de 2 cavidades con !Ir_l_j_rm_ Para su proteccion contra choques dimensiones de 42 _/8"... - Page 12 Puerta del horno 4. Ajustando la Altura del Horno (Para modelos con I Vzcavidades solamente) Retire y ponga a un lado la rejilla baja de ventilacion que esta pegada a la parte exterior del panel del horno. rejilla sera fijada a la parte de baja del frente del gabinete despues de que este haya sido instalado en el gabinete.
- Page 13 B. Modelo con 2 Cavidades Introduzca el artefacto en el recortado. Capucha electrodomestico debe ser sujetado en su lugar. Utilice Remuevatornillo-,-_::::_ los dos tornillos provistos en la bolsa de piezas varias para montar el electrodomestico en los orificios de montaje a cada lado de! armazon del horno, por encima de la puerta (figura 7).
- Page 14 Para evitarqueel pilotoseapague (sipuede aplicarse), IMPORTANTE: Antes de conectar la tuberia de gas al cierre todaslasaberturas delacavidad delgabinete que horno mueva la platina de soporte de la valvula de cierre encierra la unida,Tambien c ualquier abertura alrededor completamente hacia la izquierda y apriete el tornillo delassalidas d elservicio degasdebenestar cerrados e n que la sostiene desde debajo del homo, Esto asegura...
- Page 15 B. Ajuste del orificio del quemador del horno 9. ConversiOn de Gas Propano/ (vea figura Licuado Pasador A. Conversion del regulador de presion Nota: No remueva el regulador de presion. Convertir el regulador de presion para que se pueda usar con Gas LP/Propano (vea figura k_unta en Si necesario, remueva al asador o el cajon de Obturador de aire...
- Page 16 10. Conversion de Gas Natural Para gas natural la entrada de aire debera estar aproximadamente medio abierta. Para gas LP la entrada Convertir la unidad de Gas LP/Propano a Gas de aire debera estar casi totalmente abierta. Natural, proceda de la siguiente manerar (vea figura Demasiado aire haria que la llama se alejara del A.
- Page 17 Asegurese de incluir el modelo, numero de serie y el 12. Verifique la operacion numero o letra de lore que se encuentran en la placa, Refiera al Manual del Usuario que viene con el horno en todo pedido de partes o solicitud de informacion empotrado para las instrucciones de funcionamiento y el acerca de su horno empotrado.
- Page 18 CLOCK RELOJ THERMOSTAT TERMOSTATO nVEN LAMP SWITCH INTERRUPTOR LUZ DE HORNO CONNECTOR CONNECTOR CONECTOR CDNECTDR OVEN LAMP DE HDRNO OVEN LAMP SWITCH UNTERRUPTOR DE LUZ DE HORNO ® CLOCK RELOJ OVEN LAMP DE HORNn © ® ® _LVO_ HORNO GVEN THERMOSTAT OVEN IGNITER...
- Page 19 DOOR SW[TCH CONTROL BOARD BL/W- I SEE BELOW FOR CONNECTION 3R-I ---03 mcO--.. LOCK MOTOR BROIL BAKE 0v- i SEE LEGEND V- I _--- PROBE ,)E7 E_,) E6(b THERMAL CIRCU]T BREAKER LEGEND BK-1 LATCH MOTOR BROIL IGNITER I a BL-I A.D.S.
- Page 20 OVEN LAMP SWITCH CLOCK INTERRUPTBR DE THERMOSTAT LUZ DE HORNO RELOJ TERMOSTATO CONNECTOR CONNECTOR x CONECTOR CONECTOR CLOCK RELOJ _4_DOOR LAMP SWITCH INT. DE LUZ DE PUERTA IND. ,F ..LALMApMAPR OVEN LAMP :..%_°!°____ i LUZ DE HORNO OVEN LAMP SWITCH INT, DE LUZ DE PUERTA OVEN...