Before Setting Oven Controls ... 8 Before Setting Surface Controls ... 9 Setting Surface Controls ... 10 Oven Control Functions (300) ... 11 www.frigidaire.com USA 1-800-944-9044 & Care TA B L E O F C O N T E N T S Setting Oven Controls ...
If you do need service, help is only a phone call away. Call Frigidaire Customer Services at 1-800-944-9044. Product Registration Registering your product with Frigidaire enhances our ability to serve you. You can register online at www.frigidaire.com or by dropping your Product Registration Card in the mail.
Ask your dealer to recommend a qualified technician and an authorized repair service. Know how to disconnect the power to the range at the circuit breaker or fuse box in case of an emergency. Save these instructions for future reference.
Page 4
For electric ignition models only: Do not attempt to operate the range during a power failure. If the power fails, always turn off the range. If the range is not turned off and the power resumes, the range will begin to operate again.
Page 5
• Use care when opening oven door , warmer drawer or lower oven door—Stand to the side of the range when opening the door of a hot oven. Let hot air or steam escape before you remove or replace food in the oven.
Conversion to Liquefied Petroleum Gas WARNING Personal injury or death from electrical shock may occur if the range is not installed by a qualified installer or electrician. Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by a qualified technician.
21. 17,000 BTU burner (some models). 22. Broil pan (some models). 23. Broil pan insert (some models). 24. Leveling legs and anti-tip bracket (included). Be sure to visit us online at www.frigidaire.com for a complete line of accessories. FEATURES AT A GLANCE...
BEFORE SETTING OVEN CONTROLS Oven vent location The oven vent is located below the control panel (See Fig. 1). When the oven is on, warm air passes through this vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block the oven vent.
IMPORTANT Do not place aluminum foil, or ANY material that can melt on the range cooktop. If these items melt they may damage the cooktop. NOTE The size and type of utensil used, and the amount and type of food being cooked will influence the setting needed for best cooking results.
• Do not place aluminum foil, or ANY material that can melt on the range cooktop. If these items melt they may permanently damage the cooktop surface. • In the event of an electrical power outage, the surface burners can be lit manually.
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various pad features and functions of the oven as described below. Feature indicator Bake time pad— Use lights— These to enter the length of indicator lights show baking time desired.
SETTING OVEN CONTROLS Setting a silent control panel When choosing a function, a tone will be heard each time a keypad is pressed. If desired, the control can be programmed for silent operation. To block the controls from sounding when any keypad is pressed in the future, press and hold start time keypad for 6 seconds.
Setting bake The oven can be programmed to bake at any temperature from 170°F to 550°F (77°C to 287°C). The factory preset automatic bake temperature is 350°F (177°C). To set bake 1. Press bake. "— — —" appears in the display. 2.
SETTING OVEN CONTROLS Setting bake time and start time The bake time and start time pads may be used to set the length of baking time and to delay the starting time (delayed timed bake). The oven will turn on at a later time and stop automatically after the set bake time ends.
Setting broil Use the broil feature to cook meats that require direct exposure to flame heat for optimum browning results. When broiling always remember to arrange the oven racks while oven is still cool. Position the oven rack as suggested in the broil settings table (See Fig. 3). To set broil 1.
SETTING OVEN CONTROLS Adjusting the oven temperature Your appliance has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you think the oven is cooking too hot or too cool for your recipe times, you can adjust the control so the oven cooks hotter or cooler than the temperature displayed.
These areas are shown in white (See Fig. 1). SELF-CLEANING CAUTION During the self-cleaning cycle, the outside of the range can become very hot to the touch. DO NOT leave small children unattended near the appliance. The health of some birds is extremely sensitive to the fumes given off during the Self-cleaning cycle of any range.
Whenever the self-clean feature is active you may check the amount of time remaining by pressing the clean pad. Remember the range door cannot be opened until the range has cooled sufficiently. You will need to add about 1 hour to the time displayed before you can use the range for cooking.
Surface type • Control knobs • Painted body parts • Painted decorative trim • Aluminum, plastic or vinyl trim pieces • Control panel • Decorative trim (some models) • Stainless Steel (some models) • Porcelain enamel broiler pan and broiler pan insert (if equipped) •...
CARE & CLEANING Cleaning the cooktop and surface burners CAUTION • To avoid possible burns DO NOT attempt any of the cleaning instructions provided below before turning OFF all of the surface burners and allow them to cool. • Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized qualified Agency.
Replacing oven light CAUTION Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass. The light bulb is located at the rear of the oven cavity and is covered with a glass shield held by a wire holder.
Care & Cleaning section for additional cleaning instructions. • Range power cord is disconnected from outlet (electric ignition models only). Be sure power cord is securely plugged into the power outlet. • Electrical power outage (electric ignition models only). Burners can be lit manually.
Page 23
• Be sure the light is secure in the socket. Also see “Replacing oven light” in the Care & Cleaning section. • Be sure floor is level, strong & stable enough to adequately support range. • If floor is sagging or sloping, contact a carpenter to correct the situation.
Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.