Connecting The Am Antenna; Connecting The Speakers - JVC MX-KC4 Instructions Manual
Compact component system
Hide thumbs
Also See for MX-KC4:
- Service manual (61 pages) ,
- Instructions manual (29 pages) ,
- Instructions manual (56 pages)
Table of Contents
Advertisement
Getting Started
Connecting
the AM Antenna
Rear Panel of the Unit
AM loop antenna (Supplied
Turnthe loop until you have
the best reception.
Attach the AM loop to its base by
snapping the tabs on the loop
into the slot in the base.
• Even when connecting an outside AM antenna, keep the indoor AM loop connected.
CA UTION:
• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.
Connecting
the
Speakers
Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. "Right" / "Left" is labeled
on the rear of the speaker.
1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords to the Speaker terminals of the Unit.
Connect the gray (+) and gray with black stripe (-) cords of the right side speaker to the red (+) and black (-) terminals marked RIGHT
on the System.
Connect the gray (+) and gray with black stripe (-) cords of the left side speaker to the red (+) and black (-) terminals marked LEFT on
the System.
3. Close each of the terminals.
Right
side (rear
view)
Left side (rear view)
Gray
CA UTIONS:
• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away
from the TV.
• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
