Advertisement
Quick Links
Deck Lift Assist Kit
Zero-Turn-Radius Riding Mower
Model No. 132-6850
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Drill template
Template-mounting screws
Template-mounting nuts
Nut
Shoulder bolt
Extension-spring assembly
Spring support
Spring-support screws
Spring-assembly bolt
Note: Determine the left and right sides of the machine from the normal operating position.
Shutoff the engine and wait for all moving parts to stop.
Preparing for the Kit
For 2014 and 2015 Models Only
1. Install the drill template to the deck-lift lever with the
template template-mounting screws and nuts
1).
Note: Make sure that the template-mounting screws
and nuts are tight and that the template is tight against
the deck-lift lever.
2. Center punch the shoulder-bolt hole
3. Remove the drill template.
4. Over the center-punch mark, drill a 1/8-inch diameter
pilot hole and then drill a 25/64-inch diameter hole.
Original Instructions (EN)
Qty.
1
2
Prepare for the kit (for 2014 and 2015 models only).
2
1
1
1
Install the kit.
1
2
1
(Figure
1. Drill template
(Figure
1)
2. Deck-lift lever
3. Template-mounting nuts
Form No. 3397-778 Rev A
Installation Instructions
Use
Figure 1
4. Shoulder-bolt hole
5. Template-mounting
screws
Printed in the USA
*3397-778* A
All Rights Reserved
Advertisement
Related Manuals for Toro 132-6850
Summary of Contents for Toro 132-6850
- Page 1 Form No. 3397-778 Rev A Deck Lift Assist Kit Zero-Turn-Radius Riding Mower Model No. 132-6850 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Drill template Template-mounting screws Prepare for the kit (for 2014 and 2015 models only).
- Page 2 Installing the Kit 1. Move the deck to the lowest height-of-cut position. 2. Install the shoulder bolt and nut onto the deck-lift lever (Figure 3); torque the shoulder bolt to 36.5 to 44.7 N∙m (324 to 396 in-lb). 3. Remove 1 of the existing screws from the deck-lift plate and loosely replace it with 1 of the spring-support screws (Figure...