Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG 740 D
Summary of Contents for AEG 740 D
- Page 1 740 D Campana extractora Dunstabzugshaube Cooker Hood Cappa aspirante Kjøkkenventilator Instrucciones de montaje y manejo Montage- und Gebrauchsanweisung Operating and Installation Instructions Istruzioni di montaggio e uso Montering- og bruksveiledning...
-
Page 2: Table Of Contents
Hood operation Maintenance and care Metal grease filter Carbon filter Changing the light bulb Cleaning Special accessories Technical assistance service Guarantee conditions Service Technic Details Installation Electrical connection Wall unit mounting Printed on recycled paper AEG - putting words into action... -
Page 3: Safety Warnings
Safety warnings for user • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control. - Page 4 • The national decree on fuel-burning systems specifies a maximum depression of 0.04 bar in such rooms. • The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed.
-
Page 5: Introduction
(special accessory). • You will need original AEG activated carbon filter for this function (see Special Accessories). • The air is discharged to the outside through a pipe, which must be fitted to connection flange A . -
Page 6: Hood Operation
Hood Operation • The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated. -
Page 7: Maintenance And Care
Maintenance and care • The hood must always be disconnected from the mains power supply before beginning any maintenance work. Metal grease filter • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. -
Page 8: Carbon Filter
• The activated carbon filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG activated carbon filter (see special accessories). • Cleaning/replacing the carbon filter The activated carbon filter must normally be replaced at least once every 6 months. -
Page 9: Changing The Light Bulb
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. -
Page 10: Cleaning
Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. •... -
Page 11: Guarantee Conditions
Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.The guarantee does not... - Page 12 Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances.
-
Page 13: Technic Details
Technic Details Dimensions: Height x Width x Depht min/max (in cm) 17,5 x 59,8 x 28,5/34 Maximum absorbed power: 320 W Motor absorption: 2 x 120 W Lighting: 2 x 40 W Length of the cable: 150 cm Fan powers (speed), speed in compliance with IEC 61591 (Extractor version) Speed: 184 m 283 m... -
Page 14: Installation
Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the volt- age indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. -
Page 15: Wall Unit Mounting
Wall unit mounting - Fig. 7 • Rest the boring template (1) supplied with the hood against the bottom of the overhead unit (the printed arrow indicates the side of the template that has to coincide with the rear edge of the overhead unit). - Page 16 Fig. 7...