INSTALLATION Position the tumble dryer so that the plug remains accessible after installation. Do not block the vent at the front or base of the dryer, as this will impair the working of the machine. This appliance must not be installed behind a lockable door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer.
Page 3
THE CONTROLS A. THE TIMER Select the required drying time based on the recommendations on the control panel. B. HEAT SWITCH(ES) Select the required heat setting based on the recommendations on the control panel. C. START BUTTON (IF FITTED) Press Start button after closing the door and selecting the required drying time.
OPERATION Open the door. Load clothes loosely into the drum. Load sheets first, starting with one corner. Close the door. Dry your hands. Check that the timer is in the ‘0’position. Plug in the machine. Select correct heat position, (see programme chart on control panel for recommendations). Set the timer to the required time setting (see programme chart on control panel for recommendations).
Failure to heat may indicate the safety cut-out has operated. To reset, simply press the red button at the rear of the machine. If it has operated then a sharp “click” will be heard. This cut-out only operates if the airflow is severely restricted so make sure the filter is clean, the air inlets and outlets at the front and back are not blocked, and that all other restrictions are removed before re- starting.
–Do not stack the tumble dryer on top of other appliances without the correct stacking kit. –Any electrical work required to install the appliance should be carried out by a qualified person. –It is important to clean the lint filter after each drying cycle or the restrictions to airflow will extend drying times and could cause the safety cut-out to trip.
Page 7
This appliance is marked according to the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). This guideline is the frame of a European wide validity of return and Recycling on Waste Electrical and Electronic Equipment.