Page 1
Quick Guide to Using the Nokia 8850 with an Infrared data connection 1. Introduction ...2 2. Windows 95 configuration ...2 2.1 Checking IrDA support in Windows 95...2 2.2 Installation of MS IrDA support for Windows 95...2 2.3 IrDA settings...3 2.4 Windows 95 Modem configuration...4 2.5 Windows 95 dial-up connection configuration ...5...
Page 2
Nokia 8850 so that internal data and fax features can be used. 2. WINDOWS 95 CONFIGURATION In order to use Nokia 8850 data and fax capabilities with Windows 95 IrDA must be installed in PC. To check if your PC has Microsoft IrDA software installed follow steps described below.
Page 3
Only for a Nokia 6100 series phone and Nokia Data Suite users: Please note : If you are using the IR connection, the IrDA and Nokia Data Suite cannot be run at the same time! So, if you are using a Nokia 6100 series phone for infrared transmission and running Nokia Data Suite under Windows 95 , and you install MS IrDA 2.0, then you will have to disable the infrared communication in the Infrared Monitor every time you...
Page 4
After proper IrDA support installation and configuration next step is to configure a new modem for Windows 95. If you have already installed PC Suite for Nokia 8850 then there is no need to add a new modem, so you can skip this part. This procedure requires a so called .INF file, which contains information about used modem.
Page 5
8. Finish After Windows 95 modem is properly installed you can start to use your data and fax applications in Windows 95 environment by selecting Nokia 8850 (or Nokia Data Card as) a modem. 2.5 Windows 95 dial-up connection configuration For remote networking also a dial-up connection must be configured properly.
Page 6
The contents of this document is provided "as is". Except as required by the applicable law, no warranty of any kind, either express or implied, is made in relation to the accuracy, reliability or content of the document. Nokia reserves the right to revise the document or withdraw it at any time without prior notice.