Advertisement
Quick Links
Loose Parts
Note:
Use the chart below to verify all parts have been shipped.
DESCRIPTION
Blades
Baffle
Bolt, 5/16"–18 x 3/4"
Locknut, 5/16"–18
Pre–Installation
1.
Remove mower unit (see Operator's Manual for
instructions).
2.
Thoroughly clean mower deck. All debris must
be removed to ensure baffle will fit properly
against mower deck.
3.
Repair all bent or damaged areas of mower deck
and replace any missing parts.
4.
Remove belt covers from mower deck.
5.
Tip mower deck upside down and block up ends
to ease installation of mulcher components.
Printed in USA
Mulching Kit
for 44" Side Discharge Mowers
MODEL NO. 59226
QTY.
3
Replaces side discharge blades.
1
4
Mount baffles inside mower deck.
4
Removing Existing Blades
1.
Remove blades and anti-scalp cups from
spindles.
Note:
POTENTIAL HAZARD
Blade is sharp.
WHAT CAN HAPPEN
Contact with sharp blade can cause serious
personal injury.
HOW TO AVOID THE HAZARD
Wear gloves or wrap sharp edges of the
blade with a rag.
FORM NO. 3322–747
INSTALLATION
INSTRUCTIONS
USE
Save blades and anti–scalp cups for use
when in side discharging mode.
Advertisement
Related Manuals for Toro 59226
Summary of Contents for Toro 59226
- Page 1 FORM NO. 3322–747 Mulching Kit for 44” Side Discharge Mowers INSTALLATION MODEL NO. 59226 INSTRUCTIONS Loose Parts Note: Use the chart below to verify all parts have been shipped. DESCRIPTION QTY. Blades Replaces side discharge blades. Baffle Bolt, 5/16”–18 x 3/4”...
- Page 2 Installation Instructions Installing Baffle Note: There is one hole that is already drilled for installing the baffle. This hole is filled by a short bolt and nut. Remove this nut and bolt and save for future use (Fig. 1 and 2). Figure 2 Baffle..
- Page 3 Installation Instructions Tighten the blade mounting bolts to 85–110 ft-lb (115–150 Nm). To determine where you need to drill holes, POTENTIAL HAZARD arrange the baffle in the mower as shown in A blade that is bent or damaged could Figure 3. Rotate the center blade to ensure that break apart and pieces could be thrown at there is a 1/4”...
- Page 4 Installation Instructions Mulching Tips Selecting The Proper Height-Of-Cut Setting To Suit Conditions – Remove approximately one inch or no more that 1/3 of the grass blade when cutting. In exceptionally lush and dense grass you may have to raise the height-of-cut setting another notch or convert to side discharge or bagging operations.