Advertisement
Quick Links
Discharge Upgrade Kit
13-32G and 13-32H Rear Engine Riding Mowers
Model No. 106-6527
Save these instructions with your Operator's Manual for
future reference.
Contents of the Kit
DESCRIPTION
Locknuts (M6)
Washers (M6)
Bolt (M6)
Locknuts (M8)
Short bolts (M6)
Straps
Washers (M8)
Washers (9 x 32 x 2.5 mm)
Bolt (M8)
Grooved pin
Washers (6.6 x 18 x 2 mm)
Hairpin
Removing the Recycler Cover
or Discharge Chute
1. Park the machine on a level surface.
2. Disengage the blade (PTO).
3. Shift the ground speed lever into Neutral and set the
parking brake.
4. Stop the engine, wait for all moving parts to stop, and
remove the ignition key.
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
5. Raise the grass collector, and remove and discard the
bolt, washer, and locknut that secure the discharge tube
to the rear plate.
QUANTITY
6
6
1
2
4
2
2
2
1. Rear plate
1
2. Discharge tube
3. Bolt
1
2
6. Remove the locknut and outer washer that secure the
discharge chute to the discharge tube as shown in
1
Figure 2 (discharge chute only).
1. Discharge tube
2. Locknut and outer washer
7. Move the height-of-cut lever to the lowest position.
1
Form No. 3329-406 Rev A
Installation Instructions
2
3
4
1
Figure 1
4. Washer
5. Locknut
1
2
Figure 2
3. Discharge chute
5
m-6339
3
m-6340a
All Rights Reserved
Printed in the USA
Advertisement
Related Manuals for Toro 13-32G
Summary of Contents for Toro 13-32G
- Page 1 Form No. 3329-406 Rev A Discharge Upgrade Kit 13-32G and 13-32H Rear Engine Riding Mowers Model No. 106-6527 Installation Instructions Save these instructions with your Operator’s Manual for 5. Raise the grass collector, and remove and discard the future reference.
- Page 2 8. Remove and discard the 4 sets of bolts, washers, and 4. Insert the template into the hole in the housing toward locknuts from the housing as shown in Figure 3. the rear as shown in the inset in Figure 5. m-5981 m-6681 Figure 3...
- Page 3 9. Install the Recycler cover or discharge chute onto the 5. Raise the grass collector and remove the hairpin, mower. 2 washers, and grooved pin that secure the discharge tube to the rear plate (Fig. 7). Note: To install the Recycler cover or the discharge chute using the straps for the first time, do one of the following: To install the Recycler cover, go to step 11 of...
- Page 4 9. Move the straps away from the the discharge chute, but 8. Move the straps away from the the discharge chute, but do not remove the straps from the housing. do not remove the straps from the housing. 10. Remove the discharge chute from the mower housing. 9.