AEG 3000 D Operating And Installation Instructions
Aeg cooktop user manual
Hide thumbs
Also See for 3000 D:
- Operating and installation manual (19 pages) ,
- Operating instructions manual (76 pages)
Related Manuals for AEG 3000 D
Summary of Contents for AEG 3000 D
- Page 1 3000 D 3010 D Dunstabzugshaube Afzuigkap Hotte aspirante Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Manuel de montage et d’utilisation Operating and Installation Instructions...
-
Page 2: Table Of Contents
Contents Safety warnings for user for kitchen unit installer Introduction Extractor version Filter version Hood operation Maintenance and care Metal grease filter Open the metal grease filter Carbon filter Changing the light bulb Cleaning Special accessories Technical assistance service Guarantee conditions Service Technic Details Installation... -
Page 3: Safety Warnings
Safety warnings for user • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control. - Page 4 The national decree on fuel-burning systems specifies a • maximum depression of 0.04 bar in such rooms. The air outlet must not be connected to chimney flues or • combustion gas ducts. The air outlet must under no circum- stances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed.
-
Page 5: Introduction
(special accessory). • To do this, use an original AEG activated charcoal filter (see Special accessories). • The air is discharged to the outside through a pipe, which must be fitted to connection flange A. -
Page 6: Hood Operation
Fig. 2 Hood Operation • Best results are obtained by using a low speed for normal conditions and high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared. -
Page 7: Maintenance And Care
Maintenance and care The hood must always be disconnected from the mains • power supply before beginning any maintenance work. Metal grease filter • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. -
Page 8: Carbon Filter
• The activated carbon filter should only be used if you want to use the hood in its filtering function. • To do this you will need an original AEG activated carbon filter (see special accessories). • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. -
Page 9: Changing The Light Bulb
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. -
Page 10: Cleaning
Cleaning • Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. •... -
Page 11: Guarantee Conditions
Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.The guarantee does not... - Page 12 Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Senlis Germany...
-
Page 13: Technic Details
Technic Details Dimensions (Extractor version): Height x Width x Depht (in cm) Dimensions (Filter version): Height x Width x Depht (in cm) Maximum absorbed power: Motor absorption: Lighting: Lenght of the cable: Fan powers (speed), speed in compliance with DIN 44971 (Extractor version) Speed: (Filter version) Speed: Flange 150 mm Ø... -
Page 14: Installation
Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. -
Page 15: Wall Unit Mounting
Wall unit mounting - Fig. 6 • First decide which functioning version is better for you. If you decide to use the hood in exhausting version we suggest to position the upper section of the chimney so that the oulet slots are not visible once installation has ended, on the contrary if is decided to use the hood in recycling version BE SURE that the side with slots is up (see also A-B- C sequence on on Fig. - Page 16 Model 3010D Fig. 6...
- Page 17 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI1M7B Ed. 05/01...