Printing method Nozzle configuration Black Color Print direction Input buffer Part number 1113615 Interfaces 10/02 EPSON Stylus C62 Size Letter Letter Legal Letter Letter 4 × 6 - 20 sheets 4 × 6 - 50 sheets Letter - 20 sheets...
Power consumption Approx. 18 W (ISO 10561 Letter Pattern) Approx. 4 W in standby mode Approx. 0.6W in power- off mode * Check the label on the back of the printer for your printer’s voltage. Environmental Temperature Operation 50 to 95 °F (10 to 35 °C) Storage* −...
Load envelopes flap edge left with the flap side down. Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper.
EPSON Stylus C62 Control Panel To diagnose some problems, check the printer’s control panel, as described below, or run a printer check (see page 5). Lights Explanation Green P light The printer is receiving a print job, charging ink, or flashes cleaning the print head.
❏ Some special media have a cut corner that you need to position on the upper right. ❏ You can load the following number of sheets of EPSON special media: For this paper name...
Replacing an Ink Cartridge To ensure good results, use genuine EPSON ink cartridges and don’t refill them. Other products may cause damage to your printer not covered by EPSON’s warranty. You cannot print if either cartridge is empty. Leave the empty cartridge installed until you have obtained a replacement.
Running the Head Cleaning Utility 1. Make sure the printer is turned on but not printing, and the red b error light is off. (If the red b light is flashing or on, you may need to replace the ink cartridge; see page 6 for details.)
(not on a network), to use the Print Head Alignment utility. 1. Make sure the printer is turned on, but not printing, and letter-size plain paper (not special ink jet paper) is loaded. Load paper that’s at least 8.27 inches (210 mm) wide to prevent ink from spraying inside the printer and smudging your printouts.
Be sure to remove the tape used in step 4 after installing the printer in its new location. 1. Turn on the printer, wait until the print head locks in the far right position, then turn off the printer. 2. Unplug the power cord from the electrical outlet. Then disconnect the printer cable from the printer.