Advertisement
Quick Links
Cement Bowl
For Compact Utility Loaders with Auger Drive Head Attachment
Model No. 22442—Serial No. 260000001 and Up
Safety
Important:
Before using this product, read the
safety section in your traction unit operator's
manual, and follow all precautions listed there.
Stability Ratings
To determine the degree of slope you can traverse
with the cement bowl installed on a traction unit, find
the stability rating for the hill position you want to
travel in the appropriate table on the following page,
then find the degree of slope for the same rating and
hill position in the Stability Data section of the traction
unit operator's manual.
Important:
If your traction unit has a rear
operator's platform, the counterweight must be
used on the platform while using the cement bowl,
or the traction unit will become unstable.
WARNING
Exceeding the maximum recommended slope
can cause the traction unit to tip, crushing
you or bystanders.
Do not drive the traction unit on a slope
steeper than the maximum recommended
slope, as determined in the following tables
and the traction unit operator's manual.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Stability with a Loaded Bowl
Stability with an Unoaded Bowl
Register at www.Toro.com.
Installation Instructions
Orientation
Front Uphill
Rear Uphill
Side Uphill
Orientation
Front Uphill
Rear Uphill
Side Uphill
Original Instructions (EN)
All Rights Reserved *3438-610* A
Printed in the USA
Form No. 3438-610 Rev A
Stability Rating
B
D
C
Stability Rating
C
C
B
Advertisement
Related Manuals for Toro 22442
Summary of Contents for Toro 22442
- Page 1 Form No. 3438-610 Rev A Cement Bowl For Compact Utility Loaders with Auger Drive Head Attachment Model No. 22442—Serial No. 260000001 and Up Installation Instructions Safety Stability with a Loaded Bowl Orientation Stability Rating Important: Before using this product, read the safety section in your traction unit operator’s...
- Page 2 Safety and Instructional Installation Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential Installing the Cement Bowl danger. Replace any decal that is damaged or lost. onto the Auger Drive Head Parts needed for this procedure: Cement bowl Bolt...
- Page 3 300 series compact utility loader without 1. Bolt 2. Nut first installing the counterweight, available from your Toro dealer. • Always keep the bowl close to the ground. Lower the loader arms as far as possible while tilting the bowl upward as far as possible.
- Page 4 Removing the Bowl from Storage the Auger Drive Head Before long term storage, wash the bowl with Set the bowl down in its storage location. mild detergent and water to remove dirt and grime. Stop the engine. Store the bowl in a clean, dry garage or storage Remove the bolt and nut securing the drive head area.