Download Print this page

Range Road RR607 Assembly Manual

1.)

Unpack all pieces from the tub & crate, empty bag with nuts, bolts and pins onto a flat surface.

2.)

Find the main frame, lay on the floor with axle tabs facing up.

3.)

Place the walking beams between the tabs on either side, there is not a right or left, either walking

beam can be used for both sides, line up the hole in the walking beam with the tabs on the frame, push

pin in to hold axles in place.

4.)

Install 13mm bolt & nut washer through the plate on the pin and and the frame tab, tighten nut & Bolt.

Install cotter pin, repeat for the opposite side.

Range Road Enterprises Ltd

Box 944

Eckville AB T0M 0X0

www.range-road.ca

RR607 Trailer

Assembly Manual

Table of Contents

Page 1 Install 13mm bolt & nut washer through the plate on the pin and and the frame tab, tighten nut & Bolt. Install cotter pin, repeat for the opposite side. Range Road Enterprises Ltd Box 944 Eckville AB T0M 0X0...
Page 2 Install frame tube into main frame, holes at coupler end face up & down. Large bolt goes through frame tube and main frame, tighten nut. Tighten 2 bolts on the side of the frame rail, then tighten retaining nuts. Range Road Enterprises Ltd Box 944 Eckville AB T0M 0X0...
Page 3 Slide tongue jack to desired position, usually about 15cm (6”) back of 1 swivel coupler bolt. 14.) Install hydraulic fitting into cylinder, install brackets and cylinder on frame, tighten all 4 bolts. Range Road Enterprises Ltd Box 944 Eckville AB T0M 0X0 www.range-road.ca...
Page 4 19.) Mount battery at this time if you have one. 20.) Add approximately 2 litres of AW32 hydraulic oil. 21.) Set tub onto frame lining up the swivel brackets. Range Road Enterprises Ltd Box 944 Eckville AB T0M 0X0 www.range-road.ca...
Page 5 26.) Connect red & black wire to a battery, Operate switch to raise and lower tub 2 or 3 times, check Hydraulic oil level, add more if needed. Range Road Enterprises Ltd Box 944 Eckville AB T0M 0X0 www.range-road.ca...