Advertisement
Quick Links
SMART TOILET CONTROL
Installation and Maintenance Instructions
THE FOLLOWING ARE CAUTIONARY STATEMENTS THAT MUST BE READ AND
FOLLOWED DURING BOTH INSTALLATION AND OPERATION.
WARNING:
Raritan Engineering Company, Inc. recommends that a qualified person or electrician install
this product. Equipment damage, injury to personnel or death could result from improper instal-
lation. Raritan Engineering Company, Inc. accepts no responsibility or liability for damage to
equipment, injury or death to personnel that may result from improper installation or operation
of this product.
WARNING:
HAZARD OF SHOCK OR FIRE
Always use recommended fuse, circuit breaker and wire size.
Motors used with this product are "Ignition Protected". They are not however, explosion-
proof as defined in 46CFR 110.15-65(e), Subchapter J-Electrical Engineering.
DO NOT run continuously for more than 30 seconds.
Control box
L480 0216jlc
Panel
Part# STC
Description:
Smart Toilet Control (STC) is a controller for flushing
toilet to optimize water use without compromising the
quality of flush.
Control consists of a controller, panel and 7' of cable.
STC is designed to automatically start a
flushing cycle if NORMAL FLUSH
WATER SAVER
WATER ONLY
the bowl when pressed and EMPTY ONLY
button evacuates the bowl. Both water only and
empty button have a time limit of eight seconds.
Flush timing of initial fill, discharge and final fill are
fully programmable from panel.
If wired, panel also shows holding tank full status.
When holding tank full LED is lit, normal and water
saver button are disabled. Water only and empty
button continue to function.
Control is reverse polarity protected. In case of
reverse polarity motors and solenoid will activate as
soon as power is connected. After reverse polarity
is corrected (within 10 minutes), unit will work as
normal.
1
or
buttons are pressed.
button brings inlet water to
Advertisement
Related Manuals for Raritan STC
Summary of Contents for Raritan STC
- Page 1 Equipment damage, injury to personnel or death could result from improper instal- lation. Raritan Engineering Company, Inc. accepts no responsibility or liability for damage to equipment, injury or death to personnel that may result from improper installation or operation of this product.
- Page 2 The Holding Tank Full LED will flash THREE times to the control. indication you have left program mode. Programming your Smart Toilet Control: TOILET FLUSH CONTROL The Raritan Smart Toilet Control is factory set to work in most installations and no programming is required. WATER NORMAL SAVER...
- Page 3 Factory default settings for the The Tank LED will flash once indicating a valid key push. The maximum water retention time is NORMAL FLUSH are as follows: 10 seconds. When finished, push the NORMAL Sequential mode: T1= 3 sec, T2= 3 sec, T3= 2 sec FLUSH button to store this value and exit.
- Page 4 Mounting Control Panel: Smart Toilet Control Panel: FIG 1 1. Cut out a hole per FIG 1, mark mounting holes using Smart Flush Control wall plate as guide. 2. Route wire to the toilet and control. 3. Secure control using mounting screws Smart Toilet Control Box: 1.
- Page 5 Recommended Wire and Fuse/Circuit Breaker Sizes ATLANTES FREEDOM VORTEX VAC AND MARINE ELEGANCE Table 1-Sea Water Model (sizes based on both inlet and discharge amps added) Circuit Remote Toilet Units Breaker/ Pump Discharge Voltage fuse size Only Amp 10 feet 15 feet 20 feet 30 feet...
- Page 6 Electroscan, connect “Head1” to distance from: “FROM MSD” ( See Fig 6). • Power Source to control box and back to For Lectra/San MC, EC call Raritan Customer power source. Service • Remote pump units -determine proper wire size for remote pump from wiring diagram.
- Page 7 TOILET FLUSH CONTROL WATER NORMAL SAVER FLUSH (12AWG) WATER EMPTY ONLY ONLY HOLDING TANK FULL RARITAN DISCHARGE BLACK PUMP (12AWG) BLACK RED/ORANGE SEE RECOMMENDED WIRE SIZE 'FOR REMOTE INTAKE PUMP ONLY Table 5' FIG 4 WIRING FOR SMART TOILET CONTROL SEA/FRESH MODEL...
- Page 8 FIG 5 PURASAN EX WIRING FOR SMART TOILET CONTROL WITH MSD BATT + WHITE DISCH + RED DISCH - BLACK INLET+ BLUE TO MSD INLET - BLACK TO MSD 16AWG FROM MSD SENSALEVEL FUSES COMMON HD NEG HD POS FLOAT EXT TRIG WALL SWITCH ELECTROSCAN...