Advertisement
Quick Links
LED Light Kit
GreensPro
Model No. 44923
This product contains a chemical or chemicals known to the State of California to
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Light mounting bracket (right)
Light mounting bracket (left)
LED light
Hex-head bolt (M6 x 20 mm)
Locknut (M6)
Washer (1/4 x 7/8 inch)
Washer (M6 x 20 mm)
Switch
Wiring harness
Cable tie
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
™
1240 Greens Roller
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
1
1
2
2
2
2
2
1
1
4
Register at www.Toro.com.
Install the LED lights.
Install the switch and the wiring harness.
Original Instructions (EN)
All Rights Reserved *3380-737* A
Printed in the UK
Form No. 3380-737 Rev A
Installation Instructions
Use
Advertisement
Related Manuals for Toro 44923
Summary of Contents for Toro 44923
- Page 1 Form No. 3380-737 Rev A LED Light Kit GreensPro ™ 1240 Greens Roller Model No. 44923 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installing the LED Lights 1. Align the left light mounting bracket with the hole in the rear left corner of the seat pan (Figure 1). Note: The bracket should be nearly parallel with the ground. If it is not, try the other bracket; refer to Figure 2.
- Page 3 Installing the Switch and the Wiring Harness 1. Remove and discard the hole plug that is installed in the hole near the hour meter in the side of the seat pan. G025245 Figure 6 Underside shown G025239 Figure 3 1. Light kit wiring harness 2.