Advertisement
Quick Links
Pull Link Kit for DPA Reel Mower Groomer
Greensmaster
Model No. 112-9248
This product contains a chemical or chemicals known to the State of California
Determine the left and right sides of the machine from the normal operating position.
Installation
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3250-D Series Traction Unit
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
Register at www.Toro.com.
WARNING
CALIFORNIA
2
Installing the Front Carrier
Frames
Parts needed for this procedure:
2
Right link bracket
2
Left link bracket
4
Carriage bolt
4
Flat washer
4
Locknut
4
Bushing
4
Long pull-arm extension
Bolt—3/8 x 1-1/2 inches (2006 and earlier machines
4
only)
4
Roller shaft (2007 and after machines only)
4
Bolt—3/8 x 2 inches (2007 and after machines only)
8
Bushing (2007 and after machines only)
2006 and Earlier Machines
1.
Slide back the sleeve on the ball-joint receiver
and remove the receiver from the ball stud
(Figure
Form No. 3416-524 Rev A
Installation Instructions
1).
Original Instructions (EN)
All Rights Reserved *3416-524* A
Printed in the USA
Advertisement
Related Manuals for Toro 112-9248
Summary of Contents for Toro 112-9248
- Page 1 Form No. 3416-524 Rev A Pull Link Kit for DPA Reel Mower Groomer Greensmaster ® 3250-D Series Traction Unit Model No. 112-9248 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 g218544 Figure 1 g218546 Figure 2 1. Roller shaft 7. Flat washer 2. Ball stud 8. Spacer 1. Roller shaft 9. Spacer 3. Ball-joint receiver 9. Bushing 2. Ball stud 10. Bushing 4. Jam nut 10. Pull-link assembly 3. Ball-joint receiver 11.
- Page 3 Note: Make sure the basket lips are parallel with the reel blades all the way across the reel blades. Tighten the jam nuts. 2007 and Later Machines Slide back the sleeve on the ball-joint receiver and remove the receiver from the ball stud (Figure g218652 Figure 4...
- Page 4 Note: Make sure that the basket lips are clearance for 2007 and after machines, between parallel with the reel blades all the way across the lip of the basket and the reel blades. the reel blades. Note: Make sure that the basket lips are Tighten the jam nuts.