Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for X-pole Xpert
Summary of Contents for X-pole Xpert
- Page 1 ® www.XPOLE.com Instruction Manual Please Read Fully Before Installation...
- Page 2 THIS BEFORE OPENING YOUR PACKAGE To get the best from your XPERT – with SAFETY being the utmost priority – it is extremely important that you READ & FOLLOW the Instruction Manual from beginning to end and most importantly, understand it! Prior to installation, all shrink-wrap covering the pole tubes and parts must be removed.
- Page 3 It is highly recommended that before you use your XPERT Pole you review some online videos to learn the basic moves. Never try moves beyond your ability without an instructor. If at any time whilst using your pole you feel uncomfortable, your muscles hurt, or you are short of breath –...
- Page 4 Checking the parts Please check the contents of your XPERT pole with the contents diagram (Fig 1.1). If anything is missing or damaged, please contact your point of purchase or call your local X-POLE office immediately (contact details on the back page).
- Page 5 A-Pole A-Pole Pole The XPERT POLE should be installed in the most Joists are beams of wood that run from wall to wall secure location possible, like under a solid ceiling – if and support your ceilings. The Upper Dome must be you do not have a solid ceiling, you will have to locate centred under the Joist.
- Page 6 ® LEADERS IN POLE & AERIAL FITNESS Finding a suitable exercise & dance area TIP: Measure a circle with a diameter (measured from one point of a circle across to another) of approximately 3000 – 3500mm (120" – 138") and locate your pole in the centre of the circle. Fig.
- Page 7 There are 3 sizes of X-Joints; 180mm (7"), 200mm The 180mm (7") X-Joint has one half longer than the (8") & 250mm (10"). The XPERT Pro is supplied with: other & is marked with an arrow (on the shorter end),...
- Page 8 ® LEADERS IN POLE & AERIAL FITNESS Assembling your X-Pole Connecting the A-POLE (main tube with screws & screw adjuster at one end) to the B-POLE. Fig. (5.1) X-Joint U Keyway Slot EXPAND EXPAND CONTRACT CONTRACT Pole Tube At the centre of the X-Joint are 2 x Keys. These Keys slide into the corresponding U Keyway slots in the pole tube.
- Page 9 LEADERS IN POLE & AERIAL FITNESS Fig. (5.5) Install Extensions at the top of the Pole. These tubes are always installed together B Pole A Pole X-JOINT EXTENSION Then, as required, keep adding X-Joints and Extensions to reach your desired height – minimising the number of joints and tubes by using optional longer extensions, available from our online shop;...
- Page 10 (200mm in the case of 40mm & Silicone poles) with a 125mm extension and make sure the ARROW is always pointing towards the ceiling. Installing Xpert CAUTION: When assembled, the pole is heavy and at full height, NOT easy to handle. It is therefore MANDATORY/COMPULSORY that 2 people install the pole –...
- Page 11 LEADERS IN POLE & AERIAL FITNESS Fig. (8.1) Fig. (8.2) Ceiling Joist 3 x Adjuster Locking Hex Screws ANTI/COUNTER - CLOCKWISE to LOOSEN Adjuster Cover With one person holding the base, the other person Now undo the 3 Adjuster Locking Hex Screws at should slowly and carefully lift the pole, raising it until the top of the Adjuster Cover with the 5mm Hex it is vertical and under the Joist.
- Page 12 Horizontal Line Adjuster Body Adjuster Cover Keyhole Tighten the XPERT pole until good positive pressure When expanding/unwinding the pole Anti/Counter- is felt and the pole is firmly in place. DO NOT exert clockwise, the adjuster cover will rise. If a horizontal too much pressure.
- Page 13 This compresses the floor and also makes it easier to rotate the pole. CAUTION: Do not over-tighten the XPERT Pole - only tighten till good positive pressure is felt and the pole is firmly in place.
- Page 14 LOOSEN Hex Key Lay the pole tubes on the floor and undo the X-Joints to disassemble the XPERT Pro. To undo the X-Joint – turn both Hex Screws Anti/Counter Clockwise – undo screws until there is pressure against the key.
- Page 15 PLEASE NOTE: ANTI-CLOCKWISE = COUNTER CLOCKWISE (A) As damage can occur from the pressure used to keep the XPERT Pro Pole in place, it is mandatory that the pole is centred under one joist. The better aligned the upper dome is under the centre of the joist and the more care taken in assembly and set-up, the less potential there is for damage.
- Page 16 If X-POLE is unable to provide a replacement and repair is not practical or cannot be made in a timely fashion, X-POLE may elect to refund the purchase price in exchange for the return of the product.