All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by RB 0272 Service PaCE...
22/11/2016 EN 2 L01.1U AC Technical Specifications, Connections and Chassis Overview 1. Technical Specifications, Connections and Chassis Overview Note: Described specifications are valid for the whole product : 2 x 5 W range. : 2 x 10 W Mono versions...
Page 3
22/11/2016 Technical Specifications, Connections and Chassis Overview L01.1U AC EN 3 Chassis Overview CRT PANEL TOP CONTROL PANEL SCAVEM FRONT INTERFACE PANEL SIDE AV PANEL + HEADPHONE "SLIM" "WIDE" POWER SUPPLY LINE DEFLECTION 2D 3LINE COMB FILTER FRAME DEFLECTION...
22/11/2016 EN 4 L01.1U AC Safety & Maintenance Instructions, Warnings, and Notes 2. Safety & Maintenance Instructions, Warnings, and Notes Index of this chapter: 3. Clean the picture tube panel and the neck of the picture 1. Safety Instructions for Repairs tube.
Page 5
22/11/2016 Safety & Maintenance Instructions, Warnings, and Notes L01.1U AC EN 5 • The picture tube panel has printed spark gaps. Each spark gap is connected between an electrode of the picture tube and the Aquadag coating. • The semiconductors indicated in the circuit diagram and in...
22/11/2016 EN 40 L01.1U AC Mechanical Instructions 4. Mechanical Instructions Index of this chapter: Family Board with bracket (with separate 'control'). 1. Set Disassembly 1. Disconnect the strain relief of the AC power cord. 2. Service Positions 2. Disconnect the degaussing coil by removing the cable from 3.
Page 41
22/11/2016 Mechanical Instructions L01.1U AC EN 41 Assembly/Board Removal 4.3.4 DAF Assembly/Board (if present) 4.3.1 Comb Filter Assembly/Board (if present) You can remove the Comb Filter panel from the family board by disconnecting it from connector 1810 (located at the top of the AC power transformer 5520).
The L01.1U AC chassis also offers the option of using • Or via ComPair (with the ComPair 'Tools' RC7150 Service ComPair, a hardware interface between a computer and the TV Remote, it should be possible to enter SDAM via the chassis.
Page 43
22/11/2016 Service Modes, Error Codes and Fault Finding L01.1U AC EN 43 – Change the value of the selected menu item. – Activate the selected submenu. • In SDAM, when you press the MENU button, the set will switch to the normal user menus (with the SDAM mode still active in the background).
Page 44
PICTURE sub menu (if necessary). 4. Press the MENU LEFT/RIGHT keys to enter the PICTURE sub menu. ComPair (Computer Aided Repair) is a service tool for Philips 5. Use the MENU UP/DOWN keys to select SHARPNESS. Consumer Electronics products. ComPair is a further 6.
Page 45
22/11/2016 Service Modes, Error Codes and Fault Finding L01.1U AC EN 45 5.4.2 Specifications ComPair consists of a Windows based faultfinding program and an interface box between PC and the product. The ComPair interface box is connected to the PC via a serial or RS232 cable.
Page 46
22/11/2016 EN 46 L01.1U AC Service Modes, Error Codes and Fault Finding the repair. This ensures that old error codes are no longer Protections present. If possible, check the entire contents of the error buffer. In If a fault situation is detected, an error code will be generated;...
22/11/2016 Block Diagram, I2C, Supply Voltage and Testpoint Overview L01.1U AC 6. Block Diagram, I C, Supply Voltage and Testpoint Overview Block Diagram SIDE AV FRONT I/O AUDIO/VIDEO BTSC-NDBX AUDIO AMPLIFIER FRONT INTFACE CONTROL +3.3V +3.3V SC2-LINA SOURCE SWITCHING...
Page 48
22/11/2016 Block Diagram, I2C, Supply Voltage and Testpoint Overview L01.1U AC C and Supply Voltage Diagram POWER SUPPLY SCAVEM LINE DEFLECTION +13V 5445 ANODE CRT FOCUS +200VA 5500 : 6500 6560 FOCUS CRT 5560 5564 5561 MAIN SUPPLY 3487...
Page 49
22/11/2016 Block Diagram, I2C, Supply Voltage and Testpoint Overview L01.1U AC Testpoint Overview Mono carrier copper track side AUDIO OUTPUT TILT 500mV / div DC 10V / div DC 20µs / div 20µs / div 7901 A8a B4 7000 TV-PROC.
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Mono Carrier: Video IF + Sound IF 0243 C6 4210 B8 0248 C2 4211 B8 0249 B2 4212 B2 VIDEO IF + SOUND IF CVBSO 0266 E11 4213 A2 A10-A 0276 C2...
Page 64
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Mono Carrier: Diversity Tables DIVERSITY TABLE FOR POWER SUPPLY DIVERSITY TABLE FOR LINE DEFLECTION DIVERSITY TABLE FOR FRONT IO + FRONT CNTL + HP For Front Control SINGLE DUAL REGION LA/AP...
Page 65
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Layout Mono Carrier: Top Side Published in Heiloo Holland...
Page 75
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Side AV + HP Panel Layout Side AV + HP Panel 0232 E5 0250-A C2 0250-B D2 SIDE AV + HP PANEL 0250-C B2 0251 A5 0254 E2 0255 E5 0277-A B1...
Page 76
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Side AV Panel + HP Panel (Slim) 0232 E4 0250-A B7 0250-B D7 SIDE AV PANEL + HP PANEL (SLIM) 0250-C A7 0251 A11 +6V8B 0254 E2 0255 E5 0277-A A6...
Page 77
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Layout Side AV Panel + HP Panel (Slim) (Top Side) Layout Side AV Panel + HP Panel (Slim) (Bottom Side) 0232 D1 0250 C1 0251 B1 0254 C1 0255 D1 1810 B1...
Page 78
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Side AV Panel + HP Panel (Wide) 0232 E4 0250-A C7 SIDE AV PANEL + HP PANEL (WIDE) 0250-B D7 0250-C B7 0251 A10 0254 E2 0255 E5 0277-A B6 0277-B D6...
Page 79
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Layout Side AV Panel + HP Panel (Wide) (Top Side) Layout Side AV Panel + HP Panel (Wide) (Bottom Side) 2171
B2 0232
C1 2172
B2 0250
B1 2173
B2 0251
B2...
Page 80
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Top Control Panel Layout Top Control Panel (Top Side) 0215 A1 1091 B3 TOP CONTROL PANEL 1092 B3 1093 B4 1094 B4 3091 A2 3092 A2 3093 A3 3094 A3 0215...
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Top Control Panel 0215 A1 0216 D1 TOP CONTROL PANEL 0217 D1 1090 D2 4086 1091 A2 FOR PCB-LAYOUT SEE NEXT PAGE 1092 A3 3086 0215 4091 4092 4093 4094 1093 A4...
Page 84
22/11/2016 Circuit Diagrams and PWB Layouts L01.1U AC Layout Top Control Panel (Top Side) Layout Top Control Panel (Bottom Side) 0215 A1 2010 A1 1091 B1 2012 D1 6092 B1 2013 D1 1092 B1 2014 D1 1095 C1 2016 D1...
22/11/2016 Alignments L01.1U AC EN 87 8. Alignments Index of this chapter: 3. Press the MENU LEFT or MENU RIGHT key to enter the 1. General Alignment Conditions WHITE TONE sub menu. 2. Hardware Alignments 4. In the WHITE TONE sub menu, press the MENU UP/ 3.
Page 88
22/11/2016 EN 88 L01.1U AC Alignments 1. To enter SDAM, press the following key sequence on the remote control transmitter: 0 6 2 5 9 6 directly followed by the MENU button (do not allow the display to time out between entries while keying the sequence).
Page 89
22/11/2016 Alignments L01.1U AC EN 89 – Turn the television set 'on' by using the 'POWER' Typenumber OP1 OP2 OP3 OP4 OP5 OP6 OP7 button on the remote control transmitter or the local 32PT5431/37R 129 1 252 152 keyboard.
Page 90
22/11/2016 EN 90 L01.1U AC Alignments 4. Press the AUTO PICTURE button on the remote control transmitter repeatedly to choose PERSONAL or MOVIES VERT. SLOPE picture mode. 5. To enter SDAM, press the following key sequence on the remote control transmitter: 0 6 2 5 9 6 directly followed by the MENU button (do not allow the display to time out VERT.
Page 91
22/11/2016 Alignments L01.1U AC EN 91 • East West Width (EWW). Select East-West Width and alignment must be performed first, before all other vertical align the picture width until the complete test pattern is alignments. Turning SBL 'on' will assist in performing this visible.
Page 92
22/11/2016 EN 92 L01.1U AC Alignments Parameter 20RF, 27V/29" 28WS 32WS 28WSRF 32WSRF 21RF, 25RF, 27RF, 29RF, 25", 28", 29"SF, 32V, 33" East-West Trapezium Vertical Slope Vertical Amplitude Vertical S-Correction Vertical Shift Vertical Zoom 8.3.5 Audio – Turn the television set 'on' by using the 'POWER' button on the remote control transmitter or the local keyboard.
EN 93 9. Circuit Description Index of this chapter: 1. Introduction The 'L01.1U AC' is divided into 2 basic systems, i.e. mono and 2. Audio Signal Processing stereo sound. While the audio processing for the mono sound 3. Video Signal Processing is done in the audio block of the UOC, an external audio 4.
Page 94
22/11/2016 EN 94 L01.1U AC Circuit Description AUDIO SOURCE SELECTION EXT. AUDIO 7801 7861 INPUT 7831 EXT. AUDIO OUT CONTROL AUDIO DECODING 7209 7210 7901 PROCESSING FM IF SELECTION BUFFER MATR. SWITCH AUDIO NOT FOR AMPL. NAFTA 7834 7835 7200 RF ANT.
Page 95
The big improvement that the 2D comb filter brings, 7200 is the elimination (or near elimination) of dot crawl. This type of filter is used in the 'L01.1U AC' chassis. When present, the filter CBA is plugged-in on connector 1810B of 51˜53 RGB/YUV RGB/YUV _IN...
Page 96
22/11/2016 EN 96 L01.1U AC Circuit Description After processing, the Y/C outputs (pins 25 and 23) are both filtered by a low-pass filter, in order to eliminate the high The following additional controls are used: frequency harmonics of this system clock.
Page 97
22/11/2016 Circuit Description L01.1U AC EN 97 second half the spot accelerates, the SCAVEM-current is The 'EHTinformation' line on pin 11 is intended to be used as a zero at the end of the slope. 'X-ray' protection. When this protection is activated (when the...
Page 98
22/11/2016 EN 98 L01.1U AC Circuit Description voltage capacitors are considerable charged. At that point in Power Supply time, the deflection coil excites through C2465. This current peak, through the high-voltage capacitor, distorts the flyback pulse. This causes synchronization errors, causing an LINE oscillation under the white line.
Page 99
22/11/2016 Circuit Description L01.1U AC EN 99 Derived Voltages The voltages supplied by the secondary windings of T5520 are: • 'MainAux' for the audio circuit (voltage depends on set execution, see table below), • 3.3 V and 3.9 V for the microprocessor and •...
Page 100
22/11/2016 EN 100 L01.1U AC Circuit Description The moment that the voltage on pin 1 drops below the 'under voltage lock out' level (UVLO = ± 9 V), the IC will stop switching and will enter a safe restart from the rectified mains voltage.
Page 101
22/11/2016 Circuit Description L01.1U AC EN 101 In Standby, the power supply works in 'burst mode'. Burst mode can be used to reduce the power consumption below 1 Active/ W at stand-by. During this mode, the controller is active...
Page 102
User Interface will not be charged to the start-up voltage. The 'L01.1U AC' uses a remote control with RC5 protocol. The incoming signal is connected to pin 67 of the UOC. The 'Top Control' keyboard, connected to UOC pin 80, can also control the set.
22/11/2016 Circuit Description L01.1U AC EN 103 information if a Y/C or CVBS source is present. The Abbreviation list presence of an external Y/C source makes this line 'high' while a CVBS source makes the line 'low'. 2 Carrier (or Channel) Stereo •...
22/11/2016 EN 104 L01.1U AC Circuit Description Horizontal Flyback Pulse: horizontal Serial Data sync pulse from large signal deflection Service Default Mode Headphone SECAM SEequence Couleur Avec Memoire. Color phase control for NTSC (not the Color system mainly used in France same as 'Tint') and East Europe.