Page 7
• Refer all servicing to qualified service personnel. Servicing is required when the clock radio has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the clock radio, the clock radio has been exposed to rain or moisture, does not operate normally, or has been dropped.
Main unit (with a battery) • User manual If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the clock radio. Write the numbers here: Model No.
RADIO • Turn on/off radio. g FM/MW • Select FM/MW tuner. h SLEEP • Set sleep timer. i CLOCK/SET AL1/SET AL2/SET TIME • Set time/alarm. • View time. j + TUNING - • Tune to radio stations. k AL1/AL2 RADIO·BUZZ •...
Note • You can only use AC power as power supply. • When power is disconnected, the display backlight is off. • The pre-installed lithium CR2032 battery can back up clock settings. When is displayed, replace the battery as indicated.
The clock radio has “plug and set” feature. When power is connected, the clock is set automatically. Select time zone Check if the time of the clock radio is consistent with the local time. If not, adjust the time zone settings according to your location. In standby mode, press TIME ZONE.
Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold 12/24H·DST for two seconds.
Note • In alarm setting mode, press and hold the hour/minute digits increase or decrease continuously. Select alarm sound To select the last heard channel or buzzer as alarm sound, switch AL1/ AL2 RADIO·BUZZ to left or right. • The gentle wake-up function is designed for all alarm sources. Activate/deactivate alarm timer Press AL1/AL2 to view alarm settings.
Snooze alarm When alarm sounds, press 6122=(/BRIGHTNESS. » The alarm snoozes and repeats ringing five minutes later. To adjust alarm interval (in minutes), press 6122=(/ BRIGHTNESS repeatedly. Listen to radio Tune to radio stations e • Position the antenna as far as possible from TV, VCR, or other radiation source.
Adjust volume f Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period. Press SLEEP repeatedly to select sleep timer period (in minutes). » When the sleep timer is activated, To deactivate the sleep timer: Press SLEEP repeatedly until [OFF] (off ) appears.
Note • To return to normal mode, repeat the above operation. displayed. Adjust display brightness Press 6122=(/BRIGHTNESS repeatedly to select different brightness level: high, mid, and low. Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power...
Tuner Tuning Range Sensitivity - Mono, 26dB S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio General information AC power Operation Power Consumption Standby Power Consumption Dimensions - Main Unit (W x H x D) Weight - With Packing - Main Unit FM: 87.5 - 108 MHz MW: 520-1620 KHz...
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power •...
Page 20
This product complies with the radio interference requirements of the European Community. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Note •...
Page 22
Norge Typeskilt finnes på apparatens underside. Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten. For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.