Related Manuals for Toro Air Rake 51551
Summary of Contents for Toro Air Rake 51551
- Page 1 FORM NO. 3321–578GB Rev A Air Raket Blower Model No. 51551—89000001 & Up Operator’s Manual...
-
Page 2: Important Safety Instructions
EN 1033. Symbol Glossary Safety alert triangle — Thrown or flying symbol within triangle objects — Whole body indicates a hazard exposure Safety alert symbol Keep dry EThe Toro Company – 1998 Printed in USA All Rights Reserved... - Page 3 Read operator’s Electrical manual shock/electrocution Consult technical manual for proper Disconnect power service procedures Do not open or remove safety shields Severing of fingers or while engine is hand—impeller blade running Wear eye protection Assembly Note: Refer to Figures section at the back of the manual. POTENTIAL HAZARD Note: Always turn off unit and unplug from electrical outlet •...
-
Page 4: Before Starting
Before Starting Operation This appliance is intended for residential use only. Securing Extension Cord Use only an extension cord recommended for outdoor use. POTENTIAL HAZARD • Debris can be thrown by unit in operator’s or bystander’s direction. POTENTIAL HAZARD WHAT CAN HAPPEN •... -
Page 5: Maintenance
• Check bag frequently for wear or deterioration. If bag Do not tip vacuum tubes upright and force feed debris into is damaged, replace it with a genuine TORO part. tubes. If the unit should start to vibrate or make abnormal noise, stop the unit, unplug the cord and check for cause. -
Page 6: Troubleshooting
Troubleshooting PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Unit won’t run or stops running 1. Unit not plugged in 1. Plug in unit 2. On/off switch in “off” position 2. Turn to “on” 3. Inlet cover or vacuum tube incorrectly 3. Secure cover or vacuum tube installed or removed 4. -
Page 7: Warranty Conditions
TORO AUSTRALIA POWER EQUIPMENT WARRANTY Subject to the warranty condition below, this tool care (in the opinion of the Company), and such (hereinafter called “the product”) is warranted by Toro warranty does not cover damage, malfunction or Australia (hereinafter called “the Company”) to be... - Page 8 Figures m-4027 1601 1604 1. Pointers aligned in lock postion 1. Model and 2. Air inlet 1. Housing 3. Tab serial number pointer decal 2. Vacuum tube pointer 1596 1571 1. Inlet cover 1. Blower tube 3. Tab 2. Blower 4.
- Page 9 Figures 1822 1597 1. Bag collar 3. Velcrot strap 2. Bag collar flange 1. Air flow adjuster m-4003 1. Cord lock 2063 1989 1. Cord lock 1576 1990 m-3990 1. Switch 1. Bag collar 3. Blower housing outlet 2. Tab 4.