Electrical Safety; Assembly And Adjustments - DeWalt DWE4884 Original Instructions Manual
Die grinder
Hide thumbs
Also See for DWE4884:
- Instructions manual (104 pages) ,
- Original instructions manual (145 pages)
Table of Contents
Advertisement
ENGLISH
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Slide switch
b. Spindle
c. Collet nut
d. Small spanner (13 mm)
e. Large spanner (17 mm)
INTENDED USE
Your die grinder has been designed for professional
grinding applications. The tool can be used with the
complete range of commercial grinding tools with a
maximum diameter of 38 mm and approved speed
of 25000/min.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This die grinder is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D
WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D
WALT service organisation.
E
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
2
conductor size is 1.5 mm
; the maximum length
is 30 m.
8
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
Switches
WARNING: Before connecting the tool
to a power supply, be sure the slider
switch is in the off position by pressing
the rear part of the switch and releasing.
Ensure the slider switch is in the off
position as described above after any
interruption in power supply to the tool,
such as the activation of a ground fault
interrupter, throwing of a circuit breaker,
accidental unplugging, or power failure.
If the slider switch is locked on when the
power is connected, the tool will start
unexpectedly.
WARNING: Grasp tool firmly with both
hands to maintain control of the tool at
start up and during use and until the
wheel or accessory stops rotating. Make
sure the wheel has come to a complete
stop be fore laying the tool down.
WARNING: To reduce unexpected tool
movement, do not switch the tool on or
off while under load conditions. Allow
the grinder to run up to full speed before
touching the work surface. Lift the tool
from the surface before turning the tool
off.
SLIDER SWITCH (FIG. 1)
To start the tool, slide the ON/OFF slider switch (a)
toward the front of the tool. To stop the tool, release
the ON/OFF slider switch.
For continuous operation, slide the switch toward
the front of the tool and press the forward part of
the switch inward. To stop the tool while operating
in continuous mode, press the rear part of the slider
switch and release.
- Quick Links:
- Technical Data
Hide quick links:
Advertisement
Table of Contents
