Connecting The Power Cords - JVC EX-A10 Instructions Manual
Compact component system
Hide thumbs
Also See for EX-A10:
- Instructions manual (56 pages) ,
- Press information (4 pages) ,
- Service manual (105 pages)
Table of Contents
Advertisement
Connections (continued)
3
Press SCAN MODE.
• The current video signal type will flash.
4
Press 2, 3 (cursor) or SCAN
MODE repeatedly to select the
video signal type suitable for
the TV.
• You can select "RGB", "Y/C" or
"PROGRESSIVE".
• Select "RGB" when a TV compatible with
composite video signals is connected to the
AV OUT terminal.
• Select "Y/C" when a TV compatible with S-
video signals is connected to the AV OUT
terminal.
• Select "PROGRESSIVE" when a TV
compatible with progressive scanning is
connected to the COMPONENT VIDEO
OUT terminals.
5
Press ENTER.
• The selected video signal type is displayed
for a short time.
NOTE
• Even if the power cord of the DVD player is
disconnected from the AC outlet or the power is
interrupted, the video signal type setting is stored.
CAUTION
• Connect the DVD player directly to a TV (or a
monitor) without routing through a video
cassette recorder (VCR). Otherwise picture
distortion may occur during playback.
DVD player
• Connecting the DVD player to a VCR-built-in-TV
may also cause picture distortion during
playback.
13
Do not turn on the power until you
complete the connection.
TV (or
monitor)
Direct connection
For the locations of the remote
control buttons, refer to page 11.
Connecting the power cords
Receiver
AC outlet
DVD player
AC outlet
• Connect the power cords after you complete the
other connections.
• The STANDBY lamps on the front panels of the
receiver and the DVD player will light up.
Receiver
(rear panel)
DVD player
(rear panel)
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
